X-Git-Url: https://git.gag.com/?a=blobdiff_plain;f=doc%2Fopenocd.texi;h=78451c71c07fa05e436bd9641fc2d5771c8fad73;hb=61a2f3284b984abee0ffd1166ecd79a0ea82976e;hp=c36047f07a2d2234024af78b087ecd4d611332e5;hpb=d7b2313b5aec47e6a4a450fdf625644ca60d633d;p=fw%2Fopenocd

diff --git a/doc/openocd.texi b/doc/openocd.texi
index c36047f07..78451c71c 100644
--- a/doc/openocd.texi
+++ b/doc/openocd.texi
@@ -2371,9 +2371,9 @@ This command is only available if your libusb1 is at least version 1.0.16.
 Specifies the @var{serial_string} of the adapter to use.
 If this command is not specified, serial strings are not checked.
 Only the following adapter drivers use the serial string from this command:
-cmsis_dap, ft232r, ftdi, kitprog.
+cmsis_dap, ft232r, ftdi, kitprog, presto, vsllink, xds110.
 The following adapters have their own command to specify the serial string:
-hla, jlink, presto, st-link, vsllink, xds110.
+hla, jlink, st-link.
 @end deffn
 
 @section Interface Drivers
@@ -3010,9 +3010,6 @@ parport cable wiggler
 
 @deffn {Interface Driver} {presto}
 ASIX PRESTO USB JTAG programmer.
-@deffn {Config Command} {presto serial} serial_string
-Configures the USB serial number of the Presto device to use.
-@end deffn
 @end deffn
 
 @deffn {Interface Driver} {rlink}
@@ -3144,11 +3141,6 @@ LaunchPad evaluation boards. The XDS110 is also available as a stand-alone USB
 debug probe with the added capability to supply power to the target board. The
 following commands are supported by the XDS110 driver:
 
-@deffn {Config Command} {xds110 serial} serial_string
-Specifies the serial number of which XDS110 probe to use. Otherwise, the first
-XDS110 found will be used.
-@end deffn
-
 @deffn {Config Command} {xds110 supply} voltage_in_millivolts
 Available only on the XDS110 stand-alone probe. Sets the voltage level of the
 XDS110 power supply. A value of 0 leaves the supply off. Otherwise, the supply