X-Git-Url: https://git.gag.com/?a=blobdiff_plain;f=doc%2Fopenocd.texi;h=19ec31b34326abfc5decb2822220771ed94a642f;hb=c6460ea36d7eeaf4a0fe4fb1a4c65bb21547afbe;hp=78451c71c07fa05e436bd9641fc2d5771c8fad73;hpb=61a2f3284b984abee0ffd1166ecd79a0ea82976e;p=fw%2Fopenocd

diff --git a/doc/openocd.texi b/doc/openocd.texi
index 78451c71c..19ec31b34 100644
--- a/doc/openocd.texi
+++ b/doc/openocd.texi
@@ -2371,9 +2371,7 @@ This command is only available if your libusb1 is at least version 1.0.16.
 Specifies the @var{serial_string} of the adapter to use.
 If this command is not specified, serial strings are not checked.
 Only the following adapter drivers use the serial string from this command:
-cmsis_dap, ft232r, ftdi, kitprog, presto, vsllink, xds110.
-The following adapters have their own command to specify the serial string:
-hla, jlink, st-link.
+cmsis_dap, ft232r, ftdi, hla, jlink, kitprog, presto, st-link, vsllink, xds110.
 @end deffn
 
 @section Interface Drivers
@@ -2848,12 +2846,6 @@ to the host. If not specified, USB addresses are not considered. Device
 selection via USB address is not always unambiguous. It is recommended to use
 the serial number instead, if possible.
 
-As a configuration command, it can be used only before 'init'.
-@end deffn
-@deffn {Config Command} {jlink serial} <serial number>
-Set the serial number of the interface, in case more than one adapter is
-connected to the host. If not specified, serial numbers are not considered.
-
 As a configuration command, it can be used only before 'init'.
 @end deffn
 @end deffn
@@ -3046,10 +3038,6 @@ version reported is V2.J21.S4.
 Currently Not Supported.
 @end deffn
 
-@deffn {Config Command} {hla_serial} serial
-Specifies the serial number of the adapter.
-@end deffn
-
 @deffn {Config Command} {hla_layout} (@option{stlink}|@option{icdi}|@option{nulink})
 Specifies the adapter layout to use.
 @end deffn
@@ -3098,10 +3086,6 @@ ST-LINK server software module}.
 @emph{Note:} ST-Link TCP server does not support the SWIM transport.
 @end deffn
 
-@deffn {Config Command} {st-link serial} serial
-Specifies the serial number of the adapter.
-@end deffn
-
 @deffn {Config Command} {st-link vid_pid} [vid pid]+
 Pairs of vendor IDs and product IDs of the device.
 @end deffn