X-Git-Url: https://git.gag.com/?a=blobdiff_plain;f=doc%2Faltusmetrum.xsl;h=c5c08d4e0e1a78073361210bc49ddb135823c2c6;hb=cb09076fe16d28e25f5b20b2178cfad10adbeddb;hp=9fdd6b07ef098fde375df9f9f415821500a412aa;hpb=bf88c5f829ea5d32043431945e862a9f6c96740a;p=fw%2Faltos

diff --git a/doc/altusmetrum.xsl b/doc/altusmetrum.xsl
index 9fdd6b07..c5c08d4e 100644
--- a/doc/altusmetrum.xsl
+++ b/doc/altusmetrum.xsl
@@ -386,6 +386,36 @@ NAR #88757, TRA #12200
         tower with a screw-driver trying to turn on your avionics before 
         installing igniters!
       </para>
+      <para>
+	TeleMini is configured via the radio link. Of course, that
+	means you need to know the TeleMini radio configuration values
+	or you won't be able to communicate with it. For situations
+	when you don't have the radio configuration values, TeleMini
+	offers an 'emergency recovery' mode. In this mode, TeleMini is
+	configured as follows:
+	<itemizedlist>
+	  <listitem>
+	    Sets the radio frequency to 434.550MHz
+	  </listitem>
+	  <listitem>
+	    Sets the radio calibration back to the factory value.
+	  </listitem>
+	  <listitem>
+	    Sets the callsign to N0CALL
+	  </listitem>
+	  <listitem>
+	    Does not go to 'pad' mode after five seconds.
+	  </listitem>
+	</itemizedlist>
+      </para>
+      <para>
+	To get into 'emergency recovery' mode, first find the row of
+	four small holes opposite the switch wiring. Using a short
+	piece of small gauge wire, connect the outer two holes
+	together, then power TeleMini up. Once the red LED is lit,
+	disconnect the wire and the board should signal that it's in
+	'idle' mode after the initial five second startup period.
+      </para>
     </section>
     <section>
       <title>GPS </title>
@@ -2649,6 +2679,7 @@ NAR #88757, TRA #12200
   <appendix
       xmlns:xi="http://www.w3.org/2001/XInclude">
     <title>Release Notes</title>
+    <simplesect><title>Version 1.2</title><xi:include	href="release-notes-1.2.xsl"  xpointer="xpointer(/article/*)"/></simplesect>
     <simplesect><title>Version 1.1.1</title><xi:include	href="release-notes-1.1.1.xsl"  xpointer="xpointer(/article/*)"/></simplesect>
     <simplesect><title>Version 1.1</title><xi:include	href="release-notes-1.1.xsl"  xpointer="xpointer(/article/*)"/></simplesect>
     <simplesect><title>Version 1.0.1</title><xi:include	href="release-notes-1.0.1.xsl"  xpointer="xpointer(/article/*)"/></simplesect>