X-Git-Url: https://git.gag.com/?a=blobdiff_plain;f=doc%2Faltusmetrum.xsl;h=036b0b6177b992de9f0b47937cb6a2d9b25a8053;hb=0ef0c50536e5eb6ad3455b5828983307edbab828;hp=431e43e6352b9c4444250922195a0c867457a4bd;hpb=e6a73d6cbe149a930f8c4e2dac655bc3f6270013;p=fw%2Faltos
diff --git a/doc/altusmetrum.xsl b/doc/altusmetrum.xsl
index 431e43e6..036b0b61 100644
--- a/doc/altusmetrum.xsl
+++ b/doc/altusmetrum.xsl
@@ -22,7 +22,7 @@
Towns
- 2013
+ 2014
Bdale Garbee and Keith Packard
@@ -35,6 +35,14 @@
+
+ 1.3.1
+ 21 January 2014
+
+ Bug fixes for TeleMega and TeleMetrum v2.0 along with a few
+ small UI improvements.
+
+
1.3
12 November 2013
@@ -1787,10 +1795,10 @@ NAR #88757, TRA #12200
rocket as it heads towards apogee.
- The height, speed and acceleration are shown along with the
- maximum values for each of them. This allows you to quickly
- answer the most commonly asked questions you'll hear during
- flight.
+ The height, speed, acceleration and tilt are shown along
+ with the maximum values for each of them. This allows you to
+ quickly answer the most commonly asked questions you'll hear
+ during flight.
The current latitude and longitude reported by the GPS are
@@ -2598,8 +2606,8 @@ NAR #88757, TRA #12200
Selecting the 'Fire Igniter' button brings up the usual device
selection dialog. Pick the desired device. This brings up another
- window which shows the current continuity test status for both
- apogee and main charges.
+ window which shows the current continuity test status for all
+ of the pyro channels.
Next, select the desired igniter to fire. This will enable the
@@ -4186,11 +4194,12 @@ NAR #88757, TRA #12200
Then, divide 434.550 MHz by the
measured frequency and multiply by the current radio cal value show
in the 'c s' command. For an unprogrammed board, the default value
- is 1186611. Take the resulting integer and program it using the 'c f'
+ is 1186611 for cc1111 based products and 7119667 for cc1120
+ based products. Take the resulting integer and program it using the 'c f'
command. Testing with the 'C' command again should show a carrier
within a few tens of Hertz of the intended frequency.
As with all 'c' sub-commands, follow this with a 'c w' to write the
- change to the parameter block in the on-board DataFlash chip.
+ change to the configuration memory.
Note that the 'reboot' command, which is very useful on the altimeters,
@@ -4447,6 +4456,13 @@ NAR #88757, TRA #12200
Release Notes
+
+ Version 1.3.1
+
+
Version 1.3