X-Git-Url: https://git.gag.com/?a=blobdiff_plain;f=Notebook;h=808d57b366a5da8069c232501732a5a5fed825cc;hb=25a59e415769ce08e571ab66cc48b876262ff481;hp=3efc7abc001a361d6ddadfe7287a996732f5443c;hpb=6b32609c8065f80cc0b94e2b22cb289351c6e914;p=hw%2Fteleterra

diff --git a/Notebook b/Notebook
index 3efc7ab..808d57b 100644
--- a/Notebook
+++ b/Notebook
@@ -16,4 +16,32 @@
 		- for prototypes, existing footprint will work with careful
 		  placement of the part and/or hand soldering after reflow
 
+2010.10.31
+- loaded and reflowed two boards
 
+	- some silkscreen work is in order .. U1/U2 refdes could be better
+	  positioned .. spots on IC's marking pin 1 should be outside chip
+
+	- tqfp footprint for tiny48 seems "largeish" .. not fatally, but 
+	  leaves me questioning a bit
+
+	- kapton paste mask worked, but was harder to use than stainless
+
+2010.11.22
+- notes from initial turn on before I forget
+
+	- the footprint for the AVR ICSP connector is mirror-imaged!
+
+	- it's easy to crowbar the 3.3V rail by over-driving the audio amp.
+	  can we run it from unregulated lipo instead?  Would be nice to do
+	  that, then crank up the gain.
+
+2011.03.14
+- if we move off speaker to an earphone jack, perhaps DK CP-3523SJCT-ND ?
+
+2011.05.05
+- be nice if the cheaper version could fit in Mouser 546-1591XXATBU, which is
+  the translucent blue Hammond 1591XXATBU
+
+- the new 2x16 displays Keith plans to test might all best be installed using
+  double sided foam tape, like DK 3M4008-ND, which is 1/8" thick and 1" wide.