X-Git-Url: https://git.gag.com/?a=blobdiff_plain;ds=sidebyside;f=tcl%2Ftarget%2Fklx.cfg;h=84f6535e35ed7ae7484ddf03f31af245bb11aad7;hb=385eedfc6f0b82c5d6715c740ee40bdce983ef04;hp=1a2ee6798e13067d967611e5d64b46243cfe5de5;hpb=e22c6484eaedd56d71011dd56e76eacab515a0d6;p=fw%2Fopenocd

diff --git a/tcl/target/klx.cfg b/tcl/target/klx.cfg
index 1a2ee6798..84f6535e3 100644
--- a/tcl/target/klx.cfg
+++ b/tcl/target/klx.cfg
@@ -26,9 +26,10 @@ if { [info exists CPUTAPID] } {
 }
 
 swj_newdap $_CHIPNAME cpu -irlen 4 -expected-id $_CPUTAPID
+dap create $_CHIPNAME.dap -chain-position $_CHIPNAME.cpu
 
 set _TARGETNAME $_CHIPNAME.cpu
-target create $_TARGETNAME cortex_m -chain-position $_CHIPNAME.cpu
+target create $_TARGETNAME cortex_m -dap $_CHIPNAME.dap
 
 $_TARGETNAME configure -work-area-phys 0x20000000 -work-area-size $_WORKAREASIZE -work-area-backup 0
 
@@ -39,13 +40,25 @@ kinetis create_banks
 # Table 5-1. Clock Summary of KL25 Sub-Family Reference Manual
 # specifies up to 1MHz for VLPR mode and up to 24MHz for run mode;
 # Table 17 of Sub-Family Data Sheet rev4 lists 25MHz as the maximum frequency.
-adapter_khz 1000
+adapter speed 1000
 
 reset_config srst_nogate
 
-if {![using_hla]} {
-   # Detect secured MCU or boot lock-up in RESET/WDOG loop
-   $_CHIPNAME.cpu configure -event examine-start {
+if {[using_hla]} {
+   echo ""
+   echo "!!!!!!!!!!!!!!!!!!!!!! WARNING !!!!!!!!!!!!!!!!! WARNING !!!!!!!!!!!!!!!!!!!!!!"
+   echo " Kinetis MCUs have a MDM-AP dedicated mainly to MCU security related functions."
+   echo " A high level adapter (like a ST-Link) you are currently using cannot access"
+   echo " the MDM-AP, so commands like 'mdm mass_erase' are not available in your"
+   echo " configuration. Also security locked state of the device will not be reported."
+   echo ""
+   echo " Be very careful as you can lock the device though there is no way to unlock"
+   echo " it without mass erase. Don't set write protection on the first block."
+   echo "!!!!!!!!!!!!!!!!!!!!!! WARNING !!!!!!!!!!!!!!!!! WARNING !!!!!!!!!!!!!!!!!!!!!!"
+   echo ""
+} else {
+   # Detect secured MCU
+   $_TARGETNAME configure -event examine-fail {
       kinetis mdm check_security
    }