#STR750 CPU
if { [info exists CHIPNAME] } {
- set _CHIPNAME $CHIPNAME
+ set _CHIPNAME $CHIPNAME
} else {
- set _CHIPNAME str750
+ set _CHIPNAME str750
}
if { [info exists ENDIAN] } {
- set _ENDIAN $ENDIAN
+ set _ENDIAN $ENDIAN
} else {
- set _ENDIAN little
+ set _ENDIAN little
}
if { [info exists CPUTAPID] } {
- set _CPUTAPID $CPUTAPID
+ set _CPUTAPID $CPUTAPID
} else {
- set _CPUTAPID 0x4f1f0041
+ set _CPUTAPID 0x4f1f0041
}
# jtag speed
-jtag_khz 10
+adapter_khz 10
#use combined on interfaces or targets that can't set TRST/SRST separately
reset_config trst_and_srst srst_pulls_trst
jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0x0f -expected-id $_CPUTAPID
#jtag nTRST and nSRST delay
-jtag_nsrst_delay 500
+adapter_nsrst_delay 500
jtag_ntrst_delay 500
set _TARGETNAME $_CHIPNAME.cpu
target create $_TARGETNAME arm7tdmi -endian little -chain-position 0 -variant arm7tdmi
-$_TARGETNAME configure -event reset-start { jtag_khz 10 }
-$_TARGETNAME configure -event reset-init { jtag_khz 3000 }
+$_TARGETNAME configure -event reset-start { adapter_khz 10 }
+$_TARGETNAME configure -event reset-init {
+ adapter_khz 3000
+
+ init_smi
+# Because the hardware cannot be interrogated for the protection state
+# of sectors, initialize all the sectors to be unprotected. The initial
+# state is reflected by the driver, too.
+ flash protect 0 0 last off
+ flash protect 1 0 last off
+}
$_TARGETNAME configure -event gdb-flash-erase-start {
flash protect 0 0 7 off
flash protect 1 0 1 off
$_TARGETNAME configure -work-area-phys 0x40000000 -work-area-size 0x4000 -work-area-backup 0
#flash bank <driver> <base> <size> <chip_width> <bus_width>
-set _FLASHNAME $_CHIPNAME.flash
+set _FLASHNAME $_CHIPNAME.flash0
flash bank $_FLASHNAME str7x 0x20000000 0x00040000 0 0 $_TARGETNAME STR75x
-set _FLASHNAME $_CHIPNAME.flash
+set _FLASHNAME $_CHIPNAME.flash1
flash bank $_FLASHNAME str7x 0x200C0000 0x00004000 0 0 $_TARGETNAME STR75x
+# Serial NOR on SMI CS0.
+set _FLASHNAME $_CHIPNAME.snor
+flash bank $_FLASHNAME stmsmi 0x80000000 0 0 0 $_TARGETNAME
+
+source [find mem_helper.tcl]
+
+proc init_smi {} {
+ mmw 0x60000030 0x01000000 0x00000000; # enable clock for GPIO regs
+ mmw 0xffffe420 0x00000001 0x00000000; # set SMI_EN bit
+ mmw 0x90000000 0x00000001 0x00000000; # set BLOCK_EN_1
+}