tcl/target: add SPDX tag
[fw/openocd] / tcl / target / str750.cfg
index 2fabc126e49d745dc62c8115293285a861dff49f..5af7b74a701350fde484d6f23115bbd983852e09 100644 (file)
@@ -1,25 +1,27 @@
+# SPDX-License-Identifier: GPL-2.0-or-later
+
 #STR750 CPU
 
 if { [info exists CHIPNAME] } {
-   set  _CHIPNAME $CHIPNAME
+   set _CHIPNAME $CHIPNAME
 } else {
-   set  _CHIPNAME str750
+   set _CHIPNAME str750
 }
 
 if { [info exists ENDIAN] } {
-   set  _ENDIAN $ENDIAN
+   set _ENDIAN $ENDIAN
 } else {
-   set  _ENDIAN little
+   set _ENDIAN little
 }
 
 if { [info exists CPUTAPID] } {
-   set  _CPUTAPID $CPUTAPID
+   set _CPUTAPID $CPUTAPID
 } else {
-   set  _CPUTAPID 0x4f1f0041
+   set _CPUTAPID 0x4f1f0041
 }
 
 # jtag speed
-adapter_khz 10
+adapter speed 10
 
 #use combined on interfaces or targets that can't set TRST/SRST separately
 reset_config trst_and_srst srst_pulls_trst
@@ -29,15 +31,15 @@ reset_config trst_and_srst srst_pulls_trst
 jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0x0f -expected-id $_CPUTAPID
 
 #jtag nTRST and nSRST delay
-adapter_nsrst_delay 500
+adapter srst delay 500
 jtag_ntrst_delay 500
 
 set _TARGETNAME $_CHIPNAME.cpu
-target create $_TARGETNAME arm7tdmi -endian little -chain-position 0 -variant arm7tdmi
+target create $_TARGETNAME arm7tdmi -endian little -chain-position 0
 
-$_TARGETNAME configure -event reset-start  { adapter_khz 10 }
+$_TARGETNAME configure -event reset-start { adapter speed 10 }
 $_TARGETNAME configure -event reset-init {
-       adapter_khz 3000
+       adapter speed 3000
 
        init_smi
 # Because the hardware cannot be interrogated for the protection state
@@ -61,7 +63,7 @@ flash bank $_FLASHNAME str7x 0x200C0000 0x00004000 0 0 $_TARGETNAME STR75x
 
 # Serial NOR on SMI CS0.
 set _FLASHNAME $_CHIPNAME.snor
-flash bank $_FLASHNAME spearsmi 0x80000000 0 0 0 $_TARGETNAME
+flash bank $_FLASHNAME stmsmi 0x80000000 0 0 0 $_TARGETNAME
 
 source [find mem_helper.tcl]