#STR750 CPU
if { [info exists CHIPNAME] } {
- set _CHIPNAME $CHIPNAME
+ set _CHIPNAME $CHIPNAME
} else {
- set _CHIPNAME str750
+ set _CHIPNAME str750
}
if { [info exists ENDIAN] } {
- set _ENDIAN $ENDIAN
+ set _ENDIAN $ENDIAN
} else {
- set _ENDIAN little
+ set _ENDIAN little
}
if { [info exists CPUTAPID] } {
- set _CPUTAPID $CPUTAPID
+ set _CPUTAPID $CPUTAPID
} else {
- set _CPUTAPID 0x4f1f0041
+ set _CPUTAPID 0x4f1f0041
}
# jtag speed
-adapter_khz 10
+adapter speed 10
#use combined on interfaces or targets that can't set TRST/SRST separately
reset_config trst_and_srst srst_pulls_trst
jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0x0f -expected-id $_CPUTAPID
#jtag nTRST and nSRST delay
-adapter_nsrst_delay 500
+adapter srst delay 500
jtag_ntrst_delay 500
set _TARGETNAME $_CHIPNAME.cpu
-target create $_TARGETNAME arm7tdmi -endian little -chain-position 0 -variant arm7tdmi
+target create $_TARGETNAME arm7tdmi -endian little -chain-position 0
-$_TARGETNAME configure -event reset-start { adapter_khz 10 }
+$_TARGETNAME configure -event reset-start { adapter speed 10 }
$_TARGETNAME configure -event reset-init {
- adapter_khz 3000
+ adapter speed 3000
init_smi
# Because the hardware cannot be interrogated for the protection state