lpc2900: use register_commands()

[fw/openocd] / tcl / target / str730.cfg

diff --git a/tcl/target/str730.cfg b/tcl/target/str730.cfg
index 53d7e1a1e4294e8175d2249061937f936c4f22f5..6432d1542841e05584a8b3f40edcad6b9f950d5e 100644 (file)
--- a/tcl/target/str730.cfg
+++ b/tcl/target/str730.cfg
@@ -2,26 +2,25 @@
 
 jtag_khz 3000
 
-if { [info exists CHIPNAME] } {        
-   set  _CHIPNAME $CHIPNAME    
-} else {        
+if { [info exists CHIPNAME] } {
+   set  _CHIPNAME $CHIPNAME
+} else {
    set  _CHIPNAME str730
 }
 
-if { [info exists ENDIAN] } {  
-   set  _ENDIAN $ENDIAN    
-} else {        
+if { [info exists ENDIAN] } {
+   set  _ENDIAN $ENDIAN
+} else {
    set  _ENDIAN little
 }
 
-if { [info exists CPUTAPID] } {        
-   set  _CPUTAPID $CPUTAPID    
-} else {        
+if { [info exists CPUTAPID] } {
+   set  _CPUTAPID $CPUTAPID
+} else {
    set  _CPUTAPID 0x3f0f0f0f
 }
 
 #use combined on interfaces or targets that can't set TRST/SRST separately
-#reset_config trst_and_srst srst_pulls_trst
 reset_config trst_and_srst srst_pulls_trst
 
 #jtag scan chain
@@ -40,8 +39,9 @@ $_TARGETNAME configure -event gdb-flash-erase-start {
        flash protect 0 0 7 off
 }
 
-$_TARGETNAME configure -work-area-virt 0 -work-area-phys 0x40000000 -work-area-size 0x4000 -work-area-backup 0
+$_TARGETNAME configure -work-area-phys 0x40000000 -work-area-size 0x4000 -work-area-backup 0
 
 #flash bank <driver> <base> <size> <chip_width> <bus_width>
-flash bank str7x 0x20000000 0x00040000 0 0 0 STR3x
+set _FLASHNAME $_CHIPNAME.flash
+flash bank $_FLASHNAME str7x 0x20000000 0x00040000 0 0 0 STR3x