flash/nor/at91samd: Use 32-bit register writes for ST-Link compat

[fw/openocd] / tcl / target / str710.cfg

diff --git a/tcl/target/str710.cfg b/tcl/target/str710.cfg
index a5955b68c83d1857cd422bc7153383e8ab7fc659..ff89717195da24e8c57775e4a0c9e7faa34d1629 100644 (file)
--- a/tcl/target/str710.cfg
+++ b/tcl/target/str710.cfg
@@ -1,22 +1,24 @@
+# SPDX-License-Identifier: GPL-2.0-or-later
+
 #start slow, speed up after reset
-adapter_khz 10
+adapter speed 10
 
 if { [info exists CHIPNAME] } {
-   set  _CHIPNAME $CHIPNAME
+   set _CHIPNAME $CHIPNAME
 } else {
-   set  _CHIPNAME str710
+   set _CHIPNAME str710
 }
 
 if { [info exists ENDIAN] } {
-   set  _ENDIAN $ENDIAN
+   set _ENDIAN $ENDIAN
 } else {
-   set  _ENDIAN little
+   set _ENDIAN little
 }
 
 if { [info exists CPUTAPID] } {
-   set  _CPUTAPID $CPUTAPID
+   set _CPUTAPID $CPUTAPID
 } else {
-   set  _CPUTAPID 0x3f0f0f0f
+   set _CPUTAPID 0x3f0f0f0f
 }
 
 #use combined on interfaces or targets that can't set TRST/SRST separately
@@ -27,11 +29,11 @@ reset_config trst_and_srst srst_pulls_trst
 jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0x0f -expected-id $_CPUTAPID
 
 set _TARGETNAME $_CHIPNAME.cpu
-target create $_TARGETNAME arm7tdmi -endian $_ENDIAN -chain-position $_TARGETNAME -variant arm7tdmi
+target create $_TARGETNAME arm7tdmi -endian $_ENDIAN -chain-position $_TARGETNAME
 
-$_TARGETNAME configure -event reset-start { adapter_khz 10 }
+$_TARGETNAME configure -event reset-start { adapter speed 10 }
 $_TARGETNAME configure -event reset-init {
-       adapter_khz 6000
+       adapter speed 6000
 
 # Because the hardware cannot be interrogated for the protection state
 # of sectors, initialize all the sectors to be unprotected. The initial
@@ -51,6 +53,3 @@ set _FLASHNAME $_CHIPNAME.flash0
 flash bank $_FLASHNAME str7x 0x40000000 0x00040000 0 0 $_TARGETNAME STR71x
 set _FLASHNAME $_CHIPNAME.flash1
 flash bank $_FLASHNAME str7x 0x400C0000 0x00004000 0 0 $_TARGETNAME STR71x
-
-# For more information about the configuration files, take a look at:
-# openocd.texi