flash/nor/at91samd: Use 32-bit register writes for ST-Link compat

[fw/openocd] / tcl / target / stm32lx_stlink.cfg

diff --git a/tcl/target/stm32lx_stlink.cfg b/tcl/target/stm32lx_stlink.cfg
deleted file mode 100644 (file)
index 0bd59b4..0000000
--- a/tcl/target/stm32lx_stlink.cfg
+++ /dev/null
@@ -1,47 +0,0 @@
-#
-# STM32lx stlink pseudo target
-#
-
-if { [info exists CHIPNAME] == 0 } {
-   set CHIPNAME stm32lx
-}
-
-if { [info exists CPUTAPID] == 0 } {
-   set CPUTAPID 0x2ba01477
-}
-
-if { [info exists WORKAREASIZE] == 0 } {
-   set WORKAREASIZE 0x2800
-}
-
-source [find target/stm32_stlink.cfg]
-
-# Flash base address is known by driver. Flash size will be probed.
-#
-# Please note that the larger stm32lx targets (256Kb and 384Kb) uses dual
-# bank flash. For such targets use target/stm32lx_dual_bank.cfg.
-#
-# Some samples of ST's stm32lx chips are known to have incorrect flash size
-# values programmed in their FLASH_SIZE register. The driver will warn
-# for strange values. It is possible to override the flash size probe by
-# defining the correct size here. Notice though that it is the size of
-# the flash bank
-#
-# flash bank stm32lx <base> <size> 0 0 <target#> <variant>
-set _FLASHNAME $_CHIPNAME.flash
-flash bank $_FLASHNAME stm32lx 0 0 0 0 $_TARGETNAME
-
-proc stm32l_enable_HSI {} {
-       # Enable HSI as clock source
-       echo "STM32L: Enabling HSI"
-
-       # Set HSION in RCC_CR
-       mww 0x40023800 0x00000101
-
-       # Set HSI as SYSCLK
-       mww 0x40023808 0x00000001
-}
-
-$_TARGETNAME configure -event reset-init {
-       stm32l_enable_HSI
-}