Flash, FRAM and EEPROM driver for STM32 QUAD-/OCTOSPI interface

[fw/openocd] / tcl / target / stm32l4x.cfg

diff --git a/tcl/target/stm32l4x.cfg b/tcl/target/stm32l4x.cfg
index 46e6f7e0db9fe8c92b380054dead5c9f482e6fc9..7f08f3c4bab79ac1135c54fc4ae10eec5a5244e3 100644 (file)
--- a/tcl/target/stm32l4x.cfg
+++ b/tcl/target/stm32l4x.cfg
@@ -50,6 +50,23 @@ $_TARGETNAME configure -work-area-phys 0x20000000 -work-area-size $_WORKAREASIZE
 set _FLASHNAME $_CHIPNAME.flash
 flash bank $_FLASHNAME stm32l4x 0 0 0 0 $_TARGETNAME
 
+if { [info exists QUADSPI] && $QUADSPI } {
+   set a [llength [flash list]]
+   set _QSPINAME $_CHIPNAME.qspi
+   flash bank $_QSPINAME stmqspi 0x90000000 0 0 0 $_TARGETNAME 0xA0001000
+} else {
+   if { [info exists OCTOSPI1] && $OCTOSPI1 } {
+      set a [llength [flash list]]
+      set _OCTOSPINAME1 $_CHIPNAME.octospi1
+      flash bank $_OCTOSPINAME1 stmqspi 0x90000000 0 0 0 $_TARGETNAME 0xA0001000
+   }
+   if { [info exists OCTOSPI2] && $OCTOSPI2 } {
+      set b [llength [flash list]]
+      set _OCTOSPINAME2 $_CHIPNAME.octospi2
+      flash bank $_OCTOSPINAME2 stmqspi 0x70000000 0 0 0 $_TARGETNAME 0xA0001400
+   }
+}
+
 # Common knowledges tells JTAG speed should be <= F_CPU/6.
 # F_CPU after reset is MSI 4MHz, so use F_JTAG = 500 kHz to stay on
 # the safe side.