tcl/board: Add NXP FRDM-K64F

[fw/openocd] / tcl / target / stm32l4x.cfg

diff --git a/tcl/target/stm32l4x.cfg b/tcl/target/stm32l4x.cfg
index 46e6f7e0db9fe8c92b380054dead5c9f482e6fc9..5899791938edf2484c29d2f9cdc3d6327b9bc923 100644 (file)
--- a/tcl/target/stm32l4x.cfg
+++ b/tcl/target/stm32l4x.cfg
@@ -47,8 +47,25 @@ target create $_TARGETNAME cortex_m -endian $_ENDIAN -dap $_CHIPNAME.dap
 
 $_TARGETNAME configure -work-area-phys 0x20000000 -work-area-size $_WORKAREASIZE -work-area-backup 0
 
-set _FLASHNAME $_CHIPNAME.flash
-flash bank $_FLASHNAME stm32l4x 0 0 0 0 $_TARGETNAME
+flash bank $_CHIPNAME.flash stm32l4x 0x08000000 0 0 0 $_TARGETNAME
+flash bank $_CHIPNAME.otp   stm32l4x 0x1fff7000 0 0 0 $_TARGETNAME
+
+if { [info exists QUADSPI] && $QUADSPI } {
+   set a [llength [flash list]]
+   set _QSPINAME $_CHIPNAME.qspi
+   flash bank $_QSPINAME stmqspi 0x90000000 0 0 0 $_TARGETNAME 0xA0001000
+} else {
+   if { [info exists OCTOSPI1] && $OCTOSPI1 } {
+      set a [llength [flash list]]
+      set _OCTOSPINAME1 $_CHIPNAME.octospi1
+      flash bank $_OCTOSPINAME1 stmqspi 0x90000000 0 0 0 $_TARGETNAME 0xA0001000
+   }
+   if { [info exists OCTOSPI2] && $OCTOSPI2 } {
+      set b [llength [flash list]]
+      set _OCTOSPINAME2 $_CHIPNAME.octospi2
+      flash bank $_OCTOSPINAME2 stmqspi 0x70000000 0 0 0 $_TARGETNAME 0xA0001400
+   }
+}
 
 # Common knowledges tells JTAG speed should be <= F_CPU/6.
 # F_CPU after reset is MSI 4MHz, so use F_JTAG = 500 kHz to stay on