cfg: Don't check BS TAP IDCODE in STM32 configs

[fw/openocd] / tcl / target / stm32l1.cfg

diff --git a/tcl/target/stm32l1.cfg b/tcl/target/stm32l1.cfg
index 7754c84939e4b898aa9b54fa8508b0a7686ab980..a8d6fdf257f2a15003b7f4a279d7232a1e0cdb4a 100644 (file)
--- a/tcl/target/stm32l1.cfg
+++ b/tcl/target/stm32l1.cfg
@@ -46,28 +46,8 @@ if { [info exists CPUTAPID] } {
 
 swj_newdap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPID
 
-if { [info exists BSTAPID] } {
-   # FIXME this never gets used to override defaults...
-   set _BSTAPID $BSTAPID
-} else {
-   # See STM Document RM0038 Section 30.6.1 Rev. 12
-
-   # Low and medium density
-   set _BSTAPID1 0x06416041
-   # Cat.2 device (medium+ density)
-   set _BSTAPID2 0x06429041
-   # Cat.3 device (medium+ density)
-   set _BSTAPID3 0x06427041
-   # Cat.4 device, STM32L15/6xxD or Cat.3 device, some STM32L15/6xxC-A models
-   set _BSTAPID4 0x06436041
-   # Cat.5 device (high density), STM32L15/6xxE
-   set _BSTAPID5 0x06437041
-}
-
 if {[using_jtag]} {
-   swj_newdap $_CHIPNAME bs -irlen 5 \
-   -expected-id $_BSTAPID1 -expected-id $_BSTAPID2 -expected-id $_BSTAPID3 \
-   -expected-id $_BSTAPID4 -expected-id $_BSTAPID5
+   jtag newtap $_CHIPNAME bs -irlen 5
 }
 
 set _TARGETNAME $_CHIPNAME.cpu
@@ -114,8 +94,8 @@ $_TARGETNAME configure -event examine-end {
        mmw 0xE0042004 0x00000007 0
 
        # Stop watchdog counters during halt
-       # DBGMCU_APB1_FZ = DBG_IWDG_STOP | DBG_WWDG_STOP
-       mww 0xE0042008 0x00001800
+       # DBGMCU_APB1_FZ |= DBG_IWDG_STOP | DBG_WWDG_STOP
+       mmw 0xE0042008 0x00001800 0
 }
 
 $_TARGETNAME configure -event trace-config {