set _CHIPNAME stm32f7x
}
- set _ENDIAN little
+set _ENDIAN little
# Work-area is a space in RAM used for flash programming
# By default use 128kB
# the Flash via ITCM alias as virtual
flash bank $_CHIPNAME.itcm-flash.alias virtual 0x00200000 0 0 0 $_TARGETNAME $_FLASHNAME
+if { [info exists QUADSPI] && $QUADSPI } {
+ set a [llength [flash list]]
+ set _QSPINAME $_CHIPNAME.qspi
+ flash bank $_QSPINAME stmqspi 0x90000000 0 0 0 $_TARGETNAME 0xA0001000
+}
+
# adapter speed should be <= F_CPU/6. F_CPU after reset is 16MHz, so use F_JTAG = 2MHz
adapter speed 2000
#
# This target is compatible with connect_assert_srst, which may be set in a
# board file.
-reset_config srst_only srst_nogate
+reset_config srst_nogate
if {![using_hla]} {
# if srst is not fitted use SYSRESETREQ to
# Reduce speed since CPU speed will slow down to 16MHz with the reset
adapter speed 2000
}
-