set _CHIPNAME lpc2378
}
-if { [info exists ENDIAN] } {
- set _ENDIAN $ENDIAN
-} else {
- set _ENDIAN little
-}
-
if { [info exists CPUTAPID ] } {
set _CPUTAPID $CPUTAPID
} else {
}
#delays on reset lines
-jtag_nsrst_delay 200
+adapter_nsrst_delay 200
jtag_ntrst_delay 200
# LPC2000 -> SRST causes TRST
jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPID
set _TARGETNAME $_CHIPNAME.cpu
-target create $_TARGETNAME arm7tdmi -endian $_ENDIAN -chain-position $_TARGETNAME -variant arm7tdmi-s_r4
+target create $_TARGETNAME arm7tdmi -chain-position $_TARGETNAME
# LPC2378 has 32kB of SRAM on its main system bus (so-called Local On-Chip SRAM)
$_TARGETNAME configure -work-area-phys 0x40000000 -work-area-size 0x8000 -work-area-backup 0
# LPC2378 has 512kB of FLASH, but upper 8kB are occupied by bootloader.
# After reset the chip uses its internal 4MHz RC oscillator
-#flash bank lpc2000 <base> <size> 0 0 <target#> <variant>
+# flash bank <name> lpc2000 <base> <size> 0 0 <target#> <variant> <clock> [calc checksum]
set _FLASHNAME $_CHIPNAME.flash
flash bank $_FLASHNAME lpc2000 0x0 0x0007D000 0 0 $_TARGETNAME lpc2000_v2 4000 calc_checksum
# 4MHz / 6 = 666kHz, so use 500
-jtag_khz 500
+adapter_khz 500