tcl/target/at91sam3u4e.cfg: changed case in dependent file

[fw/openocd] / tcl / target / lpc2378.cfg

diff --git a/tcl/target/lpc2378.cfg b/tcl/target/lpc2378.cfg
index 34b9963f93f223a6ac718c6055b85d173ab6da58..4e50ac5c856977fd3dbb88cff7b50e75ecb098f9 100644 (file)
--- a/tcl/target/lpc2378.cfg
+++ b/tcl/target/lpc2378.cfg
@@ -31,11 +31,11 @@ set _TARGETNAME $_CHIPNAME.cpu
 target create $_TARGETNAME arm7tdmi -endian $_ENDIAN -chain-position $_TARGETNAME -variant arm7tdmi-s_r4
 
 # LPC2378 has 32kB of SRAM on its main system bus (so-called Local On-Chip SRAM)
-$_TARGETNAME configure -work-area-virt 0 -work-area-phys 0x40000000 -work-area-size 0x8000 -work-area-backup 0
+$_TARGETNAME configure -work-area-phys 0x40000000 -work-area-size 0x8000 -work-area-backup 0
 
 $_TARGETNAME configure -event reset-init {
        # Force target into ARM state
-       armv4_5 core_state arm
+       arm core_state arm
        #do not remap 0x0000-0x0020 to anything but the flash
        mwb 0xE01FC040 0x01
 }
@@ -43,7 +43,8 @@ $_TARGETNAME configure -event reset-init {
 # LPC2378 has 512kB of FLASH, but upper 8kB are occupied by bootloader.
 # After reset the chip uses its internal 4MHz RC oscillator
 #flash bank lpc2000 <base> <size> 0 0 <target#> <variant>
-flash bank lpc2000 0x0 0x0007D000 0 0 $_TARGETNAME lpc2000_v2 4000 calc_checksum
+set _FLASHNAME $_CHIPNAME.flash
+flash bank $_FLASHNAME lpc2000 0x0 0x0007D000 0 0 $_TARGETNAME lpc2000_v2 4000 calc_checksum
 
 # 4MHz / 6 = 666kHz, so use 500
 jtag_khz 500