flash/nor/at91samd: Use 32-bit register writes for ST-Link compat

[fw/openocd] / tcl / target / lpc1768.cfg

diff --git a/tcl/target/lpc1768.cfg b/tcl/target/lpc1768.cfg
deleted file mode 100644 (file)
index 182fb89..0000000
--- a/tcl/target/lpc1768.cfg
+++ /dev/null
@@ -1,53 +0,0 @@
-# NXP LPC1768 Cortex-M3 with 512kB Flash and 32kB+32kB Local On-Chip SRAM,
-
-if { [info exists CHIPNAME] } {
-       set  _CHIPNAME $CHIPNAME
-} else {
-       set  _CHIPNAME lpc1768
-}
-
-# After reset the chip is clocked by the ~4MHz internal RC oscillator.
-# When board-specific code (reset-init handler or device firmware)
-# configures another oscillator and/or PLL0, set CCLK to match; if
-# you don't, then flash erase and write operations may misbehave.
-# (The ROM code doing those updates cares about core clock speed...)
-#
-# CCLK is the core clock frequency in KHz
-if { [info exists CCLK ] } {
-       set _CCLK $CCLK
-} else {
-       set _CCLK 4000
-}
-if { [info exists CPUTAPID ] } {
-       set _CPUTAPID $CPUTAPID
-} else {
-       set _CPUTAPID 0x4ba00477
-}
-
-#delays on reset lines
-jtag_nsrst_delay 200
-jtag_ntrst_delay 200
-
-# LPC2000 & LPC1700 -> SRST causes TRST
-reset_config srst_pulls_trst
-
-jtag newtap $_CHIPNAME cpu -irlen 4 -expected-id $_CPUTAPID
-
-set _TARGETNAME $_CHIPNAME.cpu
-target create $_TARGETNAME cortex_m3 -chain-position $_TARGETNAME
-
-# LPC1768 has 32kB of SRAM In the ARMv7-M "Code" area (at 0x10000000)
-# and 32K more on AHB, in the ARMv7-M "SRAM" area, (at 0x2007c000).
-$_TARGETNAME configure -work-area-phys 0x10000000 -work-area-size 0x8000
-
-# LPC1768 has 512kB of flash memory, managed by ROM code (including a
-# boot loader which verifies the flash exception table's checksum).
-set _FLASHNAME $_CHIPNAME.flash
-flash bank $_FLASHNAME lpc2000 0x0 0x80000 0 0 $_TARGETNAME \
-       lpc1700 $_CCLK calc_checksum
-
-# JTAG clock should be CCLK/6 (unless using adaptive clocking)
-# CCLK is 4 MHz after reset, and until board-specific code (like
-# a reset-init handler) speeds it up.
-jtag_rclk [ expr 4000 / 6 ]
-$_TARGETNAME configure -event reset-start { jtag_rclk [ expr 4000 / 6]  }