# NXP LPC1768 Cortex-M3 with 512kB Flash and 32kB+32kB Local On-Chip SRAM,
+# LPC17xx chips support both JTAG and SWD transports.
+# Adapt based on what transport is active.
+source [find target/swj-dp.tcl]
+
if { [info exists CHIPNAME] } {
set _CHIPNAME $CHIPNAME
} else {
}
#delays on reset lines
-jtag_nsrst_delay 200
+adapter_nsrst_delay 200
jtag_ntrst_delay 200
-# LPC2000 & LPC1700 -> SRST causes TRST
-reset_config srst_pulls_trst
-
-jtag newtap $_CHIPNAME cpu -irlen 4 -expected-id $_CPUTAPID
+#jtag newtap $_CHIPNAME cpu -irlen 4 -expected-id $_CPUTAPID
+swj_newdap $_CHIPNAME cpu -irlen 4 -expected-id $_CPUTAPID
set _TARGETNAME $_CHIPNAME.cpu
target create $_TARGETNAME cortex_m3 -chain-position $_TARGETNAME
# LPC1768 has 512kB of flash memory, managed by ROM code (including a
# boot loader which verifies the flash exception table's checksum).
+# flash bank <name> lpc2000 <base> <size> 0 0 <target#> <variant> <clock> [calc checksum]
set _FLASHNAME $_CHIPNAME.flash
flash bank $_FLASHNAME lpc2000 0x0 0x80000 0 0 $_TARGETNAME \
lpc1700 $_CCLK calc_checksum
-# JTAG clock should be CCLK/6 (unless using adaptive clocking)
-# CCLK is 4 MHz after reset, and until board-specific code (like
-# a reset-init handler) speeds it up.
-jtag_rclk [ expr 4000 / 6 ]
-$_TARGETNAME configure -event reset-start { jtag_rclk [ expr 4000 / 6] }
+# Run with *real slow* clock by default since the
+# boot rom could have been playing with the PLL, so
+# we have no idea what clock the target is running at.
+jtag_khz 10
+
+$_TARGETNAME configure -event reset-init {
+ # Do not remap 0x0000-0x0020 to anything but the flash (i.e. select
+ # "User Flash Mode" where interrupt vectors are _not_ remapped,
+ # and reside in flash instead).
+ #
+ # See Table 612. Memory Mapping Control register (MEMMAP - 0x400F C040) bit description
+ # Bit Symbol Value Description Reset
+ # value
+ # 0 MAP Memory map control. 0
+ # 0 Boot mode. A portion of the Boot ROM is mapped to address 0.
+ # 1 User mode. The on-chip Flash memory is mapped to address 0.
+ # 31:1 - Reserved. The value read from a reserved bit is not defined. NA
+ #
+ # http://ics.nxp.com/support/documents/microcontrollers/?scope=LPC1768&type=user
+
+ mww 0x400FC040 0x01
+}