set _TARGETNAME $_CHIPNAME.cpu
target create $_TARGETNAME cortex_m -chain-position $_CHIPNAME.cpu
-# It is important that "kinetis mdm check_security" is called for
-# 'examine-end' event and not 'eximine-start'. Calling it in 'examine-start'
-# causes "kinetis mdm check_security" to fail the first time openocd
-# calls it when it tries to connect after the CPU has been power-cycled.
-$_CHIPNAME.cpu configure -event examine-end {
- kinetis mdm check_security
-}
-
$_TARGETNAME configure -work-area-phys 0x20000000 -work-area-size $_WORKAREASIZE -work-area-backup 0
set _FLASHNAME $_CHIPNAME.flash
reset_config srst_nogate
if {![using_hla]} {
+ # Detect secured MCU or boot lock-up in RESET/WDOG loop
+ $_CHIPNAME.cpu configure -event examine-start {
+ kinetis mdm check_security
+ }
+
# if srst is not fitted use SYSRESETREQ to
# perform a soft reset
cortex_m reset_config sysresetreq
}
-$_TARGETNAME configure -event reset-init {
- # Table 5-1. Clock Summary of KL25 Sub-Family Reference Manual
- # specifies up to 24MHz for run mode; Table 17 of Sub-Family Data
- # Sheet rev4 lists 25MHz as the maximum frequency.
- adapter_khz 24000
-}
+# Table 5-1. Clock Summary of KL25 Sub-Family Reference Manual
+# specifies up to 24MHz for run mode; Table 17 of Sub-Family Data
+# Sheet rev4 lists 25MHz as the maximum frequency.
+# Uncoment only if VLPR mode is not used
+#$_TARGETNAME configure -event reset-init {
+# adapter_khz 24000
+#}