SMDK6410 is not target, move file to board

[fw/openocd] / tcl / target / imx31.cfg

diff --git a/tcl/target/imx31.cfg b/tcl/target/imx31.cfg
index 61a29259000cba281459c6fcce22eb7fcb6f498a..b9eddd0659d185abeddd16a9b33e1524e5c66148 100644 (file)
--- a/tcl/target/imx31.cfg
+++ b/tcl/target/imx31.cfg
@@ -3,6 +3,8 @@
 
 reset_config trst_and_srst srst_gates_jtag
 
+adapter_nsrst_delay 5
+
 if { [info exists CHIPNAME] } {
    set  _CHIPNAME $CHIPNAME
 } else {
@@ -27,15 +29,15 @@ if { [info exists SDMATAPID ] } {
    set _SDMATAPID 0x2190101d
 }
 
-#========================================
-# The "system jtag controller"
-# IMX31 reference manual, page 6-28 - figure 6-14
-if { [info exists SJCTAPID ] } {
-   set _SJCTAPID $SJCTAPID
+if { [info exists ETBTAPID ] } {
+   set _ETBTAPID $ETBTAPID
 } else {
-   set _SJCTAPID 0x2b900f0f
+   set _ETBTAPID 0x2b900f0f
 }
-jtag newtap $_CHIPNAME sjc -irlen 4 -ircapture 0x0 -irmask 0x0 -expected-id $_SJCTAPID
+
+#========================================
+
+jtag newtap $_CHIPNAME etb -irlen 4 -irmask 0xf -expected-id $_ETBTAPID
 
 # The "SDMA" - <S>mart <DMA> controller debug tap
 # Based on some IO pins - this can be disabled & removed
@@ -58,5 +60,9 @@ set _TARGETNAME $_CHIPNAME.cpu
 target create $_TARGETNAME arm11 -endian $_ENDIAN -chain-position $_TARGETNAME
 
 
-proc power_restore {} { puts "Sensed power restore. No action." }
-proc srst_deasserted {} { puts "Sensed nSRST deasserted. No action." }
+proc power_restore {} { echo "Sensed power restore. No action." }
+proc srst_deasserted {} { echo "Sensed nSRST deasserted. No action." }
+
+# trace setup ... NOTE, "normal full" mode fudges the real ETMv3.1 mode
+etm config $_TARGETNAME 16 normal full etb
+etb config $_TARGETNAME $_CHIPNAME.etb