ioutil: make the file compile on MacOS

[fw/openocd] / tcl / target / cs351x.cfg

diff --git a/tcl/target/cs351x.cfg b/tcl/target/cs351x.cfg
index 18475ff58579fda74ee47682b06d47060263d13c..0785d538a0aa314cb16791c62a57a84b7b0902e3 100644 (file)
--- a/tcl/target/cs351x.cfg
+++ b/tcl/target/cs351x.cfg
@@ -1,22 +1,22 @@
-if { [info exists CHIPNAME] } {        
-   set  _CHIPNAME $CHIPNAME    
-} else {        
-   set  _CHIPNAME cs351x
+if { [info exists CHIPNAME] } {
+   set _CHIPNAME $CHIPNAME
+} else {
+   set _CHIPNAME cs351x
 }
 
-if { [info exists ENDIAN] } {  
-   set  _ENDIAN $ENDIAN    
-} else {        
-   set  _ENDIAN little
+if { [info exists ENDIAN] } {
+   set _ENDIAN $ENDIAN
+} else {
+   set _ENDIAN little
 }
 
-if { [info exists CPUTAPID ] } {
+if { [info exists CPUTAPID] } {
    set _CPUTAPID $CPUTAPID
 } else {
    set _CPUTAPID 0x00526fa1
 }
 
-jtag newtap $_CHIPNAME cpu  -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPID
+jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPID
 
 # Create the GDB Target.
 set _TARGETNAME $_CHIPNAME.cpu
@@ -24,7 +24,7 @@ target create $_TARGETNAME fa526 -endian $_ENDIAN -chain-position $_TARGETNAME -
 
 # There is 16K of SRAM on this chip
 # FIXME: flash programming is not working by using this work area. So comment this out for now.
-#$_TARGETNAME configure -work-area-virt 0x00000000 -work-area-phys 0x00000000 -work-area-size  0x4000 -work-area-backup 1
+#$_TARGETNAME configure -work-area-phys 0x00000000 -work-area-size 0x4000 -work-area-backup 1
 
 # This chip has a DCC ... use it
 arm7_9 dcc_downloads enable