bluenrg: add support for bluenrg-lps device and board

[fw/openocd] / tcl / target / atsamv.cfg

diff --git a/tcl/target/atsamv.cfg b/tcl/target/atsamv.cfg
index b6c48423739f914eedddbc42bb7f35dc5e833ef6..fdd835473c6b44d246f76635d91a0946d9e549cb 100644 (file)
--- a/tcl/target/atsamv.cfg
+++ b/tcl/target/atsamv.cfg
@@ -32,20 +32,28 @@ if { [info exists CPUTAPID] } {
 }
 
 swj_newdap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPID
+dap create $_CHIPNAME.dap -chain-position $_CHIPNAME.cpu
 
 set _TARGETNAME $_CHIPNAME.cpu
-target create $_TARGETNAME cortex_m -endian $_ENDIAN -chain-position $_TARGETNAME
+target create $_TARGETNAME cortex_m -endian $_ENDIAN -dap $_CHIPNAME.dap
 
 $_TARGETNAME configure -work-area-phys 0x20400000 -work-area-size $_WORKAREASIZE -work-area-backup 0
 
-adapter_khz 1800
+adapter speed 1800
 
 if {![using_hla]} {
    # if srst is not fitted use SYSRESETREQ to
    # perform a soft reset
    cortex_m reset_config sysresetreq
+
+   # Set CSW[27], which according to ARM ADI v5 appendix E1.4 maps to AHB signal
+   # HPROT[3], which according to AMBA AHB/ASB/APB specification chapter 3.7.3
+   # makes the data access cacheable. This allows reading and writing data in the
+   # CPU cache from the debugger, which is far more useful than going straight to
+   # RAM when operating on typical variables, and is generally no worse when
+   # operating on special memory locations.
+   $_CHIPNAME.dap apcsw 0x08000000 0x08000000
 }
 
 set _FLASHNAME $_CHIPNAME.flash
 flash bank $_FLASHNAME atsamv 0x00400000 0 0 0 $_TARGETNAME
-