+# SPDX-License-Identifier: GPL-2.0-or-later
+
#
-# script for Atmel SAMD, SAMR, SAML or SAMC, a CORTEX-M0 chip
+# script for Atmel SAMD, SAMR, SAML or SAMC, a Cortex-M0 chip
#
#
}
swj_newdap $_CHIPNAME cpu -irlen 4 -expected-id $_CPUTAPID
+dap create $_CHIPNAME.dap -chain-position $_CHIPNAME.cpu
set _TARGETNAME $_CHIPNAME.cpu
-target create $_TARGETNAME cortex_m -endian $_ENDIAN -chain-position $_TARGETNAME
+target create $_TARGETNAME cortex_m -endian $_ENDIAN -dap $_CHIPNAME.dap
$_TARGETNAME configure -work-area-phys 0x20000000 -work-area-size $_WORKAREASIZE -work-area-backup 0
# srst_pulls_trst is not configured here to avoid an error raised in reset halt
reset_config srst_gates_jtag
-# Atmel's EDBG (on-board cmsis-dap adapter of Xplained kits) cannot
-# stop the MCU before it starts executing code if hardware RESETN
-# line is configured by command "reset_config srst_only"
-# Use "reset_config none" (default) before flash programming.
-
# Do not use a reset button with other SWD adapter than Atmel's EDBG.
# DSU usually locks MCU in reset state until you issue a reset command
# in OpenOCD.
# This limit is most probably imposed by incorrectly handled SWD WAIT
# on some SWD adapters.
-adapter_khz 400
+adapter speed 400
# Atmel's EDBG (on-board cmsis-dap adapter of Xplained kits) works
# without problem at maximal clock speed. Atmel recommends
# adapter speed less than 10 * CPU clock.
-# adapter_khz 5000
+# adapter speed 5000
if {![using_hla]} {
# if srst is not fitted use SYSRESETREQ to