tcl/target: add SPDX tag

[fw/openocd] / tcl / target / at91sam7sx.cfg

diff --git a/tcl/target/at91sam7sx.cfg b/tcl/target/at91sam7sx.cfg
index f3cc88e99c9625e6bd73b08166c2d596f066ccc5..fee4e9ae4042dc0f686313aa356df2fe35654c65 100644 (file)
--- a/tcl/target/at91sam7sx.cfg
+++ b/tcl/target/at91sam7sx.cfg
@@ -1,19 +1,21 @@
+# SPDX-License-Identifier: GPL-2.0-or-later
+
 #use combined on interfaces or targets that can't set TRST/SRST separately
 reset_config srst_only srst_pulls_trst
 
 if { [info exists CHIPNAME] } {
-   set  _CHIPNAME $CHIPNAME
+   set _CHIPNAME $CHIPNAME
 } else {
-   set  _CHIPNAME at91sam7s
+   set _CHIPNAME at91sam7s
 }
 
 if { [info exists ENDIAN] } {
-   set  _ENDIAN $ENDIAN
+   set _ENDIAN $ENDIAN
 } else {
-   set  _ENDIAN little
+   set _ENDIAN little
 }
 
-if { [info exists CPUTAPID ] } {
+if { [info exists CPUTAPID] } {
    set _CPUTAPID $CPUTAPID
 } else {
    set _CPUTAPID 0x3f0f0f0f
@@ -23,7 +25,7 @@ jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CP
 
 set _TARGETNAME $_CHIPNAME.cpu
 
-target create $_TARGETNAME arm7tdmi -endian $_ENDIAN -chain-position $_TARGETNAME -variant arm7tdmi
+target create $_TARGETNAME arm7tdmi -endian $_ENDIAN -chain-position $_TARGETNAME
 $_TARGETNAME configure -event reset-init {
         soft_reset_halt
         # RSTC_CR : Reset peripherals
@@ -50,7 +52,4 @@ $_TARGETNAME configure -work-area-phys 0x00200000 -work-area-size 0x4000 -work-a
 
 #flash bank <driver> <base_addr> <size> <chip_width> <bus_width> <target_number> [<target_name> <banks> <sectors_per_bank> <pages_per_sector> <page_size> <num_nvmbits> <ext_freq_khz>]
 set _FLASHNAME $_CHIPNAME.flash
-flash bank $_FLASHNAME at91sam7 0 0 0 0 0 0 0 0 0 0 0 0 18432
-
-# For more information about the configuration files, take a look at:
-# openocd.texi
+flash bank $_FLASHNAME at91sam7 0 0 0 0 $_TARGETNAME 0 0 0 0 0 0 0 18432