flash/nor/at91samd: Use 32-bit register writes for ST-Link compat

[fw/openocd] / tcl / target / at91sam7se512.cfg

diff --git a/tcl/target/at91sam7se512.cfg b/tcl/target/at91sam7se512.cfg
index 7273a069bc26c49e1392756b983404a89cc7dc58..29724944b779d5aeac2b04501290dbd473503c79 100644 (file)
--- a/tcl/target/at91sam7se512.cfg
+++ b/tcl/target/at91sam7se512.cfg
@@ -1,21 +1,22 @@
+# SPDX-License-Identifier: GPL-2.0-or-later
 
 # ATMEL sam7se512
 # Example: the "Elektor Internet Radio" - EIR
 # http://www.ethernut.de/en/hardware/eir/index.html
 
 if { [info exists CHIPNAME] } {
-   set  _CHIPNAME $CHIPNAME
+   set _CHIPNAME $CHIPNAME
 } else {
-   set  _CHIPNAME sam7se512
+   set _CHIPNAME sam7se512
 }
 
 if { [info exists ENDIAN] } {
-   set  _ENDIAN $ENDIAN
+   set _ENDIAN $ENDIAN
 } else {
-   set  _ENDIAN little
+   set _ENDIAN little
 }
 
-if { [info exists CPUTAPID ] } {
+if { [info exists CPUTAPID] } {
    set _CPUTAPID $CPUTAPID
 } else {
    # Force an error until we get a good number.
@@ -30,11 +31,10 @@ jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CP
 
 # The target
 set _TARGETNAME $_CHIPNAME.cpu
-target create $_TARGETNAME arm7tdmi -endian $_ENDIAN -chain-position $_TARGETNAME -variant arm7tdmi
+target create $_TARGETNAME arm7tdmi -endian $_ENDIAN -chain-position $_TARGETNAME
 
 $_TARGETNAME configure -work-area-phys 0x00200000 -work-area-size 0x4000 -work-area-backup 0
 
 #flash bank <driver> <base_addr> <size> <chip_width> <bus_width> <target_number> [<target_name> <banks> <sectors_per_bank> <pages_per_sector> <page_size> <num_nvmbits> <ext_freq_khz>]
 set _FLASHNAME $_CHIPNAME.flash
 flash bank $_FLASHNAME at91sam7 0 0 0 0 $_TARGETNAME 0 0 0 0 0 0 0 18432
-