stlink: Add PID for V3 device without MSD

[fw/openocd] / tcl / interface / stlink.cfg

diff --git a/tcl/interface/stlink.cfg b/tcl/interface/stlink.cfg
index d747d8533c401d739f33e4d69671fff984b94587..cb8e0049456a6e5fb2980c916ca96f2ff54d56a5 100644 (file)
--- a/tcl/interface/stlink.cfg
+++ b/tcl/interface/stlink.cfg
@@ -1,12 +1,12 @@
 #
-# STMicroelectronics ST-LINK/V1, ST-LINK/V2, ST-LINK/V2-1 in-circuit
+# STMicroelectronics ST-LINK/V1, ST-LINK/V2, ST-LINK/V2-1, STLINK-V3 in-circuit
 # debugger/programmer
 #
 
-interface hla
+adapter driver hla
 hla_layout stlink
 hla_device_desc "ST-LINK"
-hla_vid_pid 0x0483 0x3744 0x0483 0x3748 0x0483 0x374b
+hla_vid_pid 0x0483 0x3744 0x0483 0x3748 0x0483 0x374b 0x0483 0x374d 0x0483 0x374e 0x0483 0x374f 0x0483 0x3752 0x0483 0x3753 0x0483 0x3754
 
 # Optionally specify the serial number of ST-LINK/V2 usb device.  ST-LINK/V2
 # devices seem to have serial numbers with unreadable characters.  ST-LINK/V2
@@ -14,4 +14,3 @@ hla_vid_pid 0x0483 0x3744 0x0483 0x3748 0x0483 0x374b
 # number reset issues.
 # eg.
 #hla_serial "\xaa\xbc\x6e\x06\x50\x75\xff\x55\x17\x42\x19\x3f"
-