tcl/interface: add SPDX tag

[fw/openocd] / tcl / interface / raspberrypi2-native.cfg

diff --git a/tcl/interface/raspberrypi2-native.cfg b/tcl/interface/raspberrypi2-native.cfg
index f846fa25dfe923569f01fd2a3e0c81cf33539b94..547df0872f311af6c5e0374702cdff88c0756b72 100644 (file)
--- a/tcl/interface/raspberrypi2-native.cfg
+++ b/tcl/interface/raspberrypi2-native.cfg
@@ -1,3 +1,5 @@
+# SPDX-License-Identifier: GPL-2.0-or-later
+
 #
 # Config for using Raspberry Pi's expansion header
 #
@@ -8,35 +10,31 @@
 # Do not forget the GND connection, pin 6 of the expansion header.
 #
 
-interface bcm2835gpio
+adapter driver bcm2835gpio
 
-bcm2835gpio_peripheral_base 0x3F000000
+bcm2835gpio peripheral_base 0x3F000000
 
 # Transition delay calculation: SPEED_COEFF/khz - SPEED_OFFSET
 # These depend on system clock, calibrated for stock 700MHz
-# bcm2835gpio_speed SPEED_COEFF SPEED_OFFSET
-bcm2835gpio_speed_coeffs 146203 36
+# bcm2835gpio speed SPEED_COEFF SPEED_OFFSET
+bcm2835gpio speed_coeffs 146203 36
 
 # Each of the JTAG lines need a gpio number set: tck tms tdi tdo
 # Header pin numbers: 23 22 19 21
-# bcm2835gpio_jtag_nums 11 25 10 9
-
-# or if you have both connected,
-# reset_config trst_and_srst srst_push_pull
+bcm2835gpio jtag_nums 11 25 10 9
 
 # Each of the SWD lines need a gpio number set: swclk swdio
-# Header pin numbers: 22 18
-bcm2835gpio_swd_nums 25 24
+# Header pin numbers: 23 22
+bcm2835gpio swd_nums 11 25
 
 # If you define trst or srst, use appropriate reset_config
 # Header pin numbers: TRST - 26, SRST - 18
 
-# bcm2835gpio_trst_num 7
+# bcm2835gpio trst_num 7
 # reset_config trst_only
 
-bcm2835gpio_srst_num 18
-reset_config srst_only srst_push_pull
+# bcm2835gpio srst_num 24
+# reset_config srst_only srst_push_pull
 
 # or if you have both connected,
 # reset_config trst_and_srst srst_push_pull
-