tcl/interface: add SPDX tag

[fw/openocd] / tcl / interface / ftdi / isodebug.cfg

diff --git a/tcl/interface/ftdi/isodebug.cfg b/tcl/interface/ftdi/isodebug.cfg
index ead28644ceec97a51f104e2a02775f5fef32721d..0a6e0807ec40313c183d48478838a1871a591ecc 100644 (file)
--- a/tcl/interface/ftdi/isodebug.cfg
+++ b/tcl/interface/ftdi/isodebug.cfg
@@ -1,27 +1,29 @@
+# SPDX-License-Identifier: GPL-2.0-or-later
+
 # isodebug v1
 # 5 kV isolated JTAG/SWD + UART adapter by Unjo AB
 
 adapter driver ftdi
-ftdi_vid_pid 0x22b7 0x150d
+ftdi vid_pid 0x22b7 0x150d
 
-ftdi_layout_init 0x0ff8 0xfffb
+ftdi layout_init 0x0ff8 0xfffb
 
-ftdi_layout_signal LED -ndata 0x0100
-ftdi_layout_signal nTRST -data 0x0200
-ftdi_layout_signal nSRST -noe 0x0400
-ftdi_layout_signal SWDIO_OE -data 0x0008
+ftdi layout_signal LED -ndata 0x0100
+ftdi layout_signal nTRST -data 0x0200
+ftdi layout_signal nSRST -noe 0x0400
+ftdi layout_signal SWDIO_OE -data 0x0008
 
 # Mode signals, either of these needs to be high to drive the JTAG/SWD pins.
 # The power-on state is low for both signals but the init setting above sets
 # JTAG_EN high.
-ftdi_layout_signal SWD_EN -data 0x1000
-ftdi_layout_signal JTAG_EN -data 0x0800
+ftdi layout_signal SWD_EN -data 0x1000
+ftdi layout_signal JTAG_EN -data 0x0800
 
 # In SWD mode, the JTAG_EN signal doubles as SWO_EN_N which switches the
 # second FTDI channel UART RxD to the SWO pin instead of the separate RxD
 # pin. Note that the default init state has this pin high so when OpenOCD
 # starts in SWD mode, SWO is by default disabled. To enable SWO tracing,
-# issue the command 'ftdi_set_signal SWO_EN 1' where tracing is configured.
+# issue the command 'ftdi set_signal SWO_EN 1' where tracing is configured.
 # To switch back to using the separate UART, SWO_EN needs to be disabled
 # before exiting OpenOCD, or the adapter replugged.
-ftdi_layout_signal SWO_EN -nalias JTAG_EN
+ftdi layout_signal SWO_EN -nalias JTAG_EN