Move TCL script files -- Step 2 of 2:

[fw/openocd] / tcl / board / x300t.cfg

diff --git a/tcl/board/x300t.cfg b/tcl/board/x300t.cfg
new file mode 100644 (file)
index 0000000..985f44e
--- /dev/null
+++ b/tcl/board/x300t.cfg
@@ -0,0 +1,30 @@
+# This is for the T-Home X300T / X301T IPTV box,
+# which are based on IPTV reference designs from Kiss/Cisco KMM-3***
+#
+# It has Sigma Designs SMP8634 chip.
+source [find target/smp8634.cfg]
+
+$_TARGETNAME configure -event reset-init { x300t_init }
+
+# 1MB CFI capable flash
+# flash bank <driver> <base> <size> <chip_width> <bus_width>
+flash bank cfi 0xac000000 0x100000 2 2 0
+
+proc x300t_init { } {
+       # Setup SDRAM config and flash mapping
+       # initialize ram
+       mww 0xa003fffc 3
+       mww 0xa003fffc 2
+       mww 0xa0030000 0xE34111BA
+       mww 0xa003fffc 0xa4444
+       mww 0xa003fffc 0
+       
+       # remap boot vector in CPU local RAM
+       mww 0xa006f000 0x60000
+       
+       # map flash to CPU address space REG_BASE_cpu_block+CPU_remap4
+       mww 0x0006f010 0x48000000
+       
+       # map flash addr to REG_BASE_cpu_block + LR_XENV_LOCATION (normally done by XOS)
+       mww 0x00061ff0 0x48000000
+}