bluenrg: add support for bluenrg-lps device and board

[fw/openocd] / tcl / board / telo.cfg

diff --git a/tcl/board/telo.cfg b/tcl/board/telo.cfg
index 126f388f2ad5eec26204b24ef235f548a8d35e0c..2c98ca3bd2a55ad7f50bf721a7c9280e3f460a2f 100644 (file)
--- a/tcl/board/telo.cfg
+++ b/tcl/board/telo.cfg
@@ -1,5 +1,5 @@
 source [find target/c100.cfg]
-# basic register defintion for C100
+# basic register definition for C100
 source [find target/c100regs.tcl]
 # board-config info
 source [find target/c100config.tcl]
@@ -8,15 +8,12 @@ source [find target/c100helper.tcl]
 
 
 # Telo board & C100 support trst and srst
-# Note that libftd2xx.so tries to assert srst
-# which break this script
-# use libftdi.so library instead with this script
 # make the reset asserted to
 # allow RC circuit to discharge for: [ms]
-adapter_nsrst_assert_width 100
+adapter srst pulse_width 100
 jtag_ntrst_assert_width 100
 # don't talk to JTAG after reset for: [ms]
-adapter_nsrst_delay 100
+adapter srst delay 100
 jtag_ntrst_delay 100
 reset_config trst_and_srst separate
 
@@ -26,11 +23,11 @@ reset_config trst_and_srst separate
 # issue telnet: reset init
 # issue gdb: monitor reset init
 $_TARGETNAME configure -event reset-init {
-       adapter_khz 100
+       adapter speed 100
        # this will setup Telo board
        setupTelo
        #turn up the JTAG speed
-       adapter_khz 3000
+       adapter speed 3000
        echo "JTAG speek now 3MHz"
        echo "type helpC100 to get help on C100"
 }