cfg: update Luminary config files

[fw/openocd] / tcl / board / telo.cfg

diff --git a/tcl/board/telo.cfg b/tcl/board/telo.cfg
index c4e5d67f48df2c84e987b6cc2b52094686455079..1c0ad762fef5f23370c8bb8bec2437cce35e8e71 100644 (file)
--- a/tcl/board/telo.cfg
+++ b/tcl/board/telo.cfg
@@ -13,10 +13,10 @@ source [find target/c100helper.tcl]
 # use libftdi.so library instead with this script
 # make the reset asserted to
 # allow RC circuit to discharge for: [ms]
-jtag_nsrst_assert_width 100
+adapter_nsrst_assert_width 100
 jtag_ntrst_assert_width 100
 # don't talk to JTAG after reset for: [ms]
-jtag_nsrst_delay 100
+adapter_nsrst_delay 100
 jtag_ntrst_delay 100
 reset_config trst_and_srst separate
 
@@ -26,11 +26,11 @@ reset_config trst_and_srst separate
 # issue telnet: reset init
 # issue gdb: monitor reset init
 $_TARGETNAME configure -event reset-init {
-       jtag_khz 100
+       adapter_khz 100
        # this will setup Telo board
        setupTelo
        #turn up the JTAG speed
-       jtag_khz 3000
+       adapter_khz 3000
        puts "JTAG speek now 3MHz"
        puts "type helpC100 to get help on C100"
 }
@@ -54,7 +54,8 @@ proc srst_deasserted {} { puts "Sensed nSRST deasserted. No action." }
 # boots from NOR on CS0:  8 MBytes CFI flash, 16-bit bus
 # it's really 16MB but the upper 8mb is controller via gpio
 # openocd does not support 'complex reads/writes' to NOR
-flash bank cfi 0x20000000 0x01000000 2 2 $_TARGETNAME
+set _FLASHNAME $_CHIPNAME.flash
+flash bank $_FLASHNAME cfi 0x20000000 0x01000000 2 2 $_TARGETNAME
 
 # writing data to memory does not work without this
-memwrite burst disable
\ No newline at end of file
+arm11 memwrite burst disable
\ No newline at end of file