flash/nor/at91samd: Use 32-bit register writes for ST-Link compat

[fw/openocd] / tcl / board / telo.cfg

diff --git a/tcl/board/telo.cfg b/tcl/board/telo.cfg
index 1d3afdf0b341f223186d014b1a847fe907f74d47..721c01975d6442389ba9ee3d770299e2b7c2317a 100644 (file)
--- a/tcl/board/telo.cfg
+++ b/tcl/board/telo.cfg
@@ -1,5 +1,7 @@
+# SPDX-License-Identifier: GPL-2.0-or-later
+
 source [find target/c100.cfg]
-# basic register defintion for C100
+# basic register definition for C100
 source [find target/c100regs.tcl]
 # board-config info
 source [find target/c100config.tcl]
@@ -10,10 +12,10 @@ source [find target/c100helper.tcl]
 # Telo board & C100 support trst and srst
 # make the reset asserted to
 # allow RC circuit to discharge for: [ms]
-adapter_nsrst_assert_width 100
+adapter srst pulse_width 100
 jtag_ntrst_assert_width 100
 # don't talk to JTAG after reset for: [ms]
-adapter_nsrst_delay 100
+adapter srst delay 100
 jtag_ntrst_delay 100
 reset_config trst_and_srst separate
 
@@ -23,11 +25,11 @@ reset_config trst_and_srst separate
 # issue telnet: reset init
 # issue gdb: monitor reset init
 $_TARGETNAME configure -event reset-init {
-       adapter_khz 100
+       adapter speed 100
        # this will setup Telo board
        setupTelo
        #turn up the JTAG speed
-       adapter_khz 3000
+       adapter speed 3000
        echo "JTAG speek now 3MHz"
        echo "type helpC100 to get help on C100"
 }