cfg: ftdi icdi enable srst open drain config

[fw/openocd] / tcl / board / telo.cfg

diff --git a/tcl/board/telo.cfg b/tcl/board/telo.cfg
index cb4bc2a321c062cfcb1bdd2c069cd8b0a34248e2..126f388f2ad5eec26204b24ef235f548a8d35e0c 100644 (file)
--- a/tcl/board/telo.cfg
+++ b/tcl/board/telo.cfg
@@ -13,10 +13,10 @@ source [find target/c100helper.tcl]
 # use libftdi.so library instead with this script
 # make the reset asserted to
 # allow RC circuit to discharge for: [ms]
-jtag_nsrst_assert_width 100
+adapter_nsrst_assert_width 100
 jtag_ntrst_assert_width 100
 # don't talk to JTAG after reset for: [ms]
-jtag_nsrst_delay 100
+adapter_nsrst_delay 100
 jtag_ntrst_delay 100
 reset_config trst_and_srst separate
 
@@ -31,24 +31,24 @@ $_TARGETNAME configure -event reset-init {
        setupTelo
        #turn up the JTAG speed
        adapter_khz 3000
-       puts "JTAG speek now 3MHz"
-       puts "type helpC100 to get help on C100"
+       echo "JTAG speek now 3MHz"
+       echo "type helpC100 to get help on C100"
 }
 
 $_TARGETNAME configure -event reset-deassert-post {
        # Force target into ARM state.
-#      soft_reset_halt # not implemented on ARM11
-       puts "Detected SRSRT asserted on C100.CPU"
+#      soft_reset_halt ;# not implemented on ARM11
+       echo "Detected SRSRT asserted on C100.CPU"
 
 }
 
 $_TARGETNAME configure -event reset-assert-post {
-  puts "Assering reset"
+  echo "Assering reset"
   #sleep 10
 }
 
-proc power_restore {} { puts "Sensed power restore. No action." }
-proc srst_deasserted {} { puts "Sensed nSRST deasserted. No action." }
+proc power_restore {} { echo "Sensed power restore. No action." }
+proc srst_deasserted {} { echo "Sensed nSRST deasserted. No action." }
 
 
 # boots from NOR on CS0:  8 MBytes CFI flash, 16-bit bus
@@ -58,4 +58,4 @@ set _FLASHNAME $_CHIPNAME.flash
 flash bank $_FLASHNAME cfi 0x20000000 0x01000000 2 2 $_TARGETNAME
 
 # writing data to memory does not work without this
-memwrite burst disable
\ No newline at end of file
+arm11 memwrite burst disable