tcl/board: add SPDX tag

[fw/openocd] / tcl / board / osk5912.cfg

diff --git a/tcl/board/osk5912.cfg b/tcl/board/osk5912.cfg
index e189d076f3da6370077a4f0ce326187ce86d2956..0759a27ac0e77a37b68174ce980c62fcbeed5e00 100644 (file)
--- a/tcl/board/osk5912.cfg
+++ b/tcl/board/osk5912.cfg
@@ -1,3 +1,5 @@
+# SPDX-License-Identifier: GPL-2.0-or-later
+
 # http://omap.spectrumdigital.com/osk5912/
 
 source [find target/omap5912.cfg]
@@ -7,6 +9,10 @@ source [find target/omap5912.cfg]
 # The TI-14 pin needs "trst_only", and J1 connecting 2 & 3.
 reset_config trst_and_srst separate
 
+# NOTE:  boards with XOMAP parts wire nSRST to nPWRON_RESET.
+# That resets everything -- including JTAG and EmbeddedICE.
+# So they must use "reset_config srst_pulls_trst".
+
 # NOTE:  an expansion board could add a trace connector ... if
 # it does, change this appropriately.  And reset_config too,
 # assuming JTAG_DIS reroutes JTAG to that connector.
@@ -15,8 +21,8 @@ etm_dummy config $_TARGETNAME
 
 # standard boards populate two 16 MB chips, but manufacturing
 # options or an expansion board could change this config.
-flash bank cfi 0x00000000 0x01000000 2 2 $_TARGETNAME
-flash bank cfi 0x01000000 0x01000000 2 2 $_TARGETNAME
+flash bank osk.u1 cfi 0x00000000 0x01000000 2 2 $_TARGETNAME
+flash bank osk.u2 cfi 0x01000000 0x01000000 2 2 $_TARGETNAME
 
 proc osk5912_init {} {
        omap5912_reset
@@ -26,3 +32,5 @@ proc osk5912_init {} {
        flash probe 1
 }
 $_TARGETNAME configure -event reset-init { osk5912_init }
+
+arm7_9 dcc_downloads enable