stlink: Add PID for V3 device without MSD

[fw/openocd] / tcl / board / numato_mimas_a7.cfg

diff --git a/tcl/board/numato_mimas_a7.cfg b/tcl/board/numato_mimas_a7.cfg
index d4012bada735ccb1190d4be8b5537cbe9e380e27..12df8913dce6afd59b207cd3bf841ed9a11d29c9 100644 (file)
--- a/tcl/board/numato_mimas_a7.cfg
+++ b/tcl/board/numato_mimas_a7.cfg
@@ -8,13 +8,13 @@
 #       Therefore, prefer external power supply.
 
 adapter driver ftdi
-ftdi_device_desc "Mimas Artix 7 FPGA Module"
-ftdi_vid_pid 0x2a19 0x1009
+ftdi device_desc "Mimas Artix 7 FPGA Module"
+ftdi vid_pid 0x2a19 0x1009
 
 # channel 0 is for custom purpose by users (like uart, fifo etc)
 # channel 1 is reserved for JTAG (by-default) or SPI (possible via changing solder jumpers)
-ftdi_channel 1
-ftdi_tdo_sample_edge falling
+ftdi channel 1
+ftdi tdo_sample_edge falling
 
 
 # FTDI Pin Layout
@@ -28,7 +28,7 @@ ftdi_tdo_sample_edge falling
 # OE_N is JTAG buffer output enable signal (active-low)
 # PROG_B is not used, so left as input to FTDI.
 #
-ftdi_layout_init 0x0008 0x004b
+ftdi layout_init 0x0008 0x004b
 reset_config none
 adapter speed 30000