target/board: Add Ampere QS|MQ config files

[fw/openocd] / tcl / board / mini2440.cfg

diff --git a/tcl/board/mini2440.cfg b/tcl/board/mini2440.cfg
index a0345387dc8603805c90785c1e0dcd38625263d3..3d01b38a27a70e708b88e9a8e3aa46bbec4aab62 100644 (file)
--- a/tcl/board/mini2440.cfg
+++ b/tcl/board/mini2440.cfg
@@ -38,7 +38,7 @@
 #     it's apt-get install libusb-dev.  When I made my config I only included
 #     --enable-jlink and --enable-usbdevs
 #
-#     I HAVE NOT Tested this throughly, so there could still be problems.
+#     I HAVE NOT Tested this thoroughly, so there could still be problems.
 #     But it should get you way ahead of the game from where I started.
 #     If you find problems (and fixes) please post them to
 #     openocd-development@lists.berlios.de and join the developers and
@@ -97,7 +97,7 @@ if { [info exists ENDIAN] } {
    set  _ENDIAN little
 }
 
-if { [info exists CPUTAPID ] } {
+if { [info exists CPUTAPID] } {
    set _CPUTAPID $CPUTAPID
 } else {
    set _CPUTAPID 0x0032409d
@@ -111,7 +111,7 @@ target create $_TARGETNAME arm920t -endian $_ENDIAN -chain-position $_TARGETNAME
 $_TARGETNAME configure -work-area-phys 0x40000000  -work-area-size 0x4000 -work-area-backup 1
 
 #reset configuration
-adapter_nsrst_delay 100
+adapter srst delay 100
 jtag_ntrst_delay 100
 reset_config trst_and_srst
 
@@ -120,7 +120,7 @@ reset_config trst_and_srst
 # IMPORTANT! See README at top of this file.
 #-------------------------------------------------------------------------
 
-    adapter_khz 12000
+    adapter speed 12000
     jtag interface
 
 #-------------------------------------------------------------------------
@@ -140,7 +140,7 @@ reset_config trst_and_srst
 
     nand device s3c2440 0
 
-    adapter_nsrst_delay 100
+    adapter srst delay 100
     jtag_ntrst_delay 100
     reset_config trst_and_srst
     init