+# SPDX-License-Identifier: GPL-2.0-or-later
+
# Hitex STR9-comStick
# http://www.hitex.com/index.php?id=383
# This works for the STR9-comStick revisions STR912CS-A1 and STR912CS-A2.
-source [find interface/hitex_str9-comstick.cfg]
+source [find interface/ftdi/hitex_str9-comstick.cfg]
# set jtag speed
-jtag_khz 3000
+adapter speed 3000
-jtag_nsrst_delay 100
+adapter srst delay 100
jtag_ntrst_delay 100
#use combined on interfaces or targets that can't set TRST/SRST separately
reset_config trst_and_srst
set _ENDIAN little
}
-if { [info exists FLASHTAPID ] } {
+if { [info exists FLASHTAPID] } {
set _FLASHTAPID $FLASHTAPID
} else {
set _FLASHTAPID 0x04570041
}
jtag newtap $_CHIPNAME flash -irlen 8 -ircapture 0x1 -irmask 0x1 -expected-id $_FLASHTAPID
-if { [info exists CPUTAPID ] } {
+if { [info exists CPUTAPID] } {
set _CPUTAPID $CPUTAPID
} else {
set _CPUTAPID 0x25966041
}
jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPID
-if { [info exists BSTAPID ] } {
+if { [info exists BSTAPID] } {
set _BSTAPID $BSTAPID
} else {
# Found on STR9-comStick, revision STR912CS-A1
$_TARGETNAME configure -work-area-phys 0x50000000 -work-area-size 16384 -work-area-backup 0
#flash bank <driver> <base> <size> <chip_width> <bus_width>
-set _FLASHNAME $_CHIPNAME.flash
+set _FLASHNAME $_CHIPNAME.flash0
flash bank $_FLASHNAME str9x 0x00000000 0x00080000 0 0 0
-set _FLASHNAME $_CHIPNAME.flash
+set _FLASHNAME $_CHIPNAME.flash1
flash bank $_FLASHNAME str9x 0x00080000 0x00008000 0 0 0