# Initial JTAG speed should not exceed 1/6 of the initial CPU clock
# frequency (24MHz). Be conservative and use 1/8 of the frequency.
# (24MHz / 8 = 3MHz)
-adapter_khz 3000
+adapter speed 3000
$_TARGETNAME configure -event reset-start {
# Upon reset, set the JTAG frequency to 3MHz again, see above.
echo "Setting JTAG speed to 3MHz until clocks are initialized."
- adapter_khz 3000
+ adapter speed 3000
# Halt the CPU.
halt
# Tests showed that 15MHz works OK, higher speeds can cause problems,
# though. Not sure if this is a CPU issue or JTAG adapter issue.
echo "Increasing JTAG speed to 15MHz."
- adapter_khz 15000
+ adapter speed 15000
# Enable faster memory access.
arm7_9 fast_memory_access enable
#######################
# TODO: Implement NAND support.
-