cpld: altera-epm240: Increase adapter speed

[fw/openocd] / tcl / board / at91sam9g20-ek.cfg

diff --git a/tcl/board/at91sam9g20-ek.cfg b/tcl/board/at91sam9g20-ek.cfg
index 03296c50e314287b868ed6c2515d82945d843bf7..e1cbb91204c796da63145cb0f7568aa68f384a5c 100644 (file)
--- a/tcl/board/at91sam9g20-ek.cfg
+++ b/tcl/board/at91sam9g20-ek.cfg
@@ -77,25 +77,25 @@ proc at91sam9g20_reset_init { } {
        # Wait for MOSCS in PMC_SR to assert indicating oscillator is again stable after change to CKGR_MOR.
 
        mww 0xfffffc20 0x00004001
-       while { [expr [read_register 0xfffffc68] & 0x01] != 1 } { sleep 1 }
+       while { [expr {[read_register 0xfffffc68] & 0x01}] != 1 } { sleep 1 }
 
        # Set PLLA Register for 792.576 MHz (divider: bypass, multiplier: 43).
        # Wait for LOCKA signal in PMC_SR to assert indicating PLLA is stable.
 
        mww 0xfffffc28 0x202a3f01
-       while { [expr [read_register 0xfffffc68] & 0x02] != 2 } { sleep 1 }
+       while { [expr {[read_register 0xfffffc68] & 0x02}] != 2 } { sleep 1 }
 
        # Set master system clock prescaler divide by 6 and processor clock divide by 2 in PMC_MCKR.
        # Wait for MCKRDY signal from PMC_SR to assert.
 
        mww 0xfffffc30 0x00000101
-       while { [expr [read_register 0xfffffc68] & 0x08] != 8 } { sleep 1 }
+       while { [expr {[read_register 0xfffffc68] & 0x08}] != 8 } { sleep 1 }
 
        # Now change PMC_MCKR register to select PLLA.
        # Wait for MCKRDY signal from PMC_SR to assert.
 
        mww 0xfffffc30 0x00001302
-       while { [expr [read_register 0xfffffc68] & 0x08] != 8 } { sleep 1 }
+       while { [expr {[read_register 0xfffffc68] & 0x08}] != 8 } { sleep 1 }
 
        # Processor and master clocks are now operating and stable at maximum frequency possible:
        #       -> MCLK = 132.096 MHz
@@ -153,7 +153,7 @@ proc at91sam9g20_reset_init { } {
 
        nand probe nandflash_cs3
 
-       # The AT91SAM9G20-EK evaluation board has build-in serial data flash also.
+       # The AT91SAM9G20-EK evaluation board has built-in serial data flash also.
 
        # Now setup SDRAM.  This is tricky and configuration is very important for reliability!  The current calculations
        # are based on 2 x Micron MT48LC16M16A2-75 memory (4 M x 16 bit x 4 banks).  If you use this file as a reference