remove in_handler usage

[fw/openocd] / src / target / target / nslu2.cfg

diff --git a/src/target/target/nslu2.cfg b/src/target/target/nslu2.cfg
index 7f8ea2814fe4bdeaaedb8f23b03f1b4fb9ef948b..529841071b8200070c69167d6a0f2384f88a96b6 100644 (file)
--- a/src/target/target/nslu2.cfg
+++ b/src/target/target/nslu2.cfg
@@ -1,22 +1,8 @@
-# use combined on interfaces or targets that can't set TRST/SRST separately
-reset_config srst_only
-
-# jtag scan chain
-#format L IRC IRCM IDCODE (Length, IR Capture, IR Capture Mask, IDCODE)
-jtag_device 7 0x1 0x7f 0x7e
-
-# target configuration
-target xscale big 0 ixp42x
-run_and_halt_time 0 30
-
-# maps to PXA internal RAM.  If you are using a PXA255
-# you must initialize SDRAM or leave this option off
-working_area 0 0x00020000 0x10000 nobackup
-
-# flash bank <driver> <base> <size> <chip_width> <bus_width>
-#flash bank cfi 0x50000000 0x1000000 2 4 0 
-
-
+# This is for the LinkSys (CISCO) NSLU2 board
+# It is an Intel XSCALE IXP420 CPU.
 
+source [find target/ixp42x.cfg]
+# The _TARGETNAME is set by the above.
 
+$_TARGETNAME configure -work-area-virt 0 -work-area-phys 0x00020000 -work-area-size 0x10000 -work-area-backup 0