Add warning to generated Doxyfile to edit Doxyfile.in.

[fw/openocd] / src / target / target / lpc2129.cfg

diff --git a/src/target/target/lpc2129.cfg b/src/target/target/lpc2129.cfg
index 82b3bad88d05249a9f3b19f64066de3b2ebea04f..b224c044321e3b81d41fe340985f74462eeefd4a 100644 (file)
--- a/src/target/target/lpc2129.cfg
+++ b/src/target/target/lpc2129.cfg
@@ -1,15 +1,41 @@
 #LPC-2129 CPU
-#use combined on interfaces or targets that can\92t set TRST/SRST separately
+
+
+if { [info exists CHIPNAME] } {        
+   set  _CHIPNAME $CHIPNAME    
+} else {        
+   set  _CHIPNAME lpc2129
+}
+
+if { [info exists ENDIAN] } {  
+   set  _ENDIAN $ENDIAN    
+} else {        
+   set  _ENDIAN little
+}
+
+if { [info exists CPUTAPID ] } {
+   set _CPUTAPID $CPUTAPID
+} else {
+  # force an error till we get a good number
+   set _CPUTAPID 0xffffffff
+}
+
+
+#use combined on interfaces or targets that can't set TRST/SRST separately
 reset_config trst_and_srst srst_pulls_trst
+
+# reset delays
+jtag_nsrst_delay 100
+jtag_ntrst_delay 100
+
 #jtag scan chain
-#format L IRC IRCM IDCODE (Length, IR Capture, IR Capture Mask, IDCODE)
-jtag_device 4 0x1 0xf 0xe
-#target configuration
-daemon_startup reset
-#target <type> <startup mode>
-#target arm7tdmi <endianness> <reset mode> <chainpos> <variant>
-target arm7tdmi little run_and_halt 0 arm7tdmi-s_r4
-run_and_halt_time 0 30
-working_area 0 0x40000000 0x4000 nobackup
+jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPID
+
+
+set _TARGETNAME [format "%s.cpu" $_CHIPNAME]
+target create $_TARGETNAME arm7tdmi -endian $_ENDIAN -chain-position $_TARGETNAME -variant arm7tdmi-s_r4
+
+$_TARGETNAME configure -work-area-virt 0 -work-area-phys 0x40000000 -work-area-size 0x4000 -work-area-backup 0
+
 #flash bank <driver> <base> <size> <chip_width> <bus_width>
 flash bank lpc2000 0x0 0x40000 0 0 0 lpc2000_v1 14765 calc_checksum