.run = jtag_dp_run,
.sync = jtag_dp_sync,
};
-
-
-static const uint8_t swd2jtag_bitseq[] = {
- /* More than 50 TCK/SWCLK cycles with TMS/SWDIO high,
- * putting both JTAG and SWD logic into reset state.
- */
- 0xff, 0xff, 0xff, 0xff, 0xff, 0xff, 0xff,
- /* Switching equence disables SWD and enables JTAG
- * NOTE: bits in the DP's IDCODE can expose the need for
- * the old/deprecated sequence (0xae 0xde).
- */
- 0x3c, 0xe7,
- /* At least 50 TCK/SWCLK cycles with TMS/SWDIO high,
- * putting both JTAG and SWD logic into reset state.
- * NOTE: some docs say "at least 5".
- */
- 0xff, 0xff, 0xff, 0xff, 0xff, 0xff, 0xff,
-};
-
-/** Put the debug link into JTAG mode, if the target supports it.
- * The link's initial mode may be either SWD or JTAG.
- *
- * @param target Enters JTAG mode (if possible).
- *
- * Note that targets implemented with SW-DP do not support JTAG, and
- * that some targets which could otherwise support it may have been
- * configured to disable JTAG signaling
- *
- * @return ERROR_OK or else a fault code.
- */
-int dap_to_jtag(struct target *target)
-{
- int retval;
-
- LOG_DEBUG("Enter JTAG mode");
-
- /* REVISIT it's nasty to need to make calls to a "jtag"
- * subsystem if the link isn't in JTAG mode...
- */
-
- retval = jtag_add_tms_seq(8 * sizeof(swd2jtag_bitseq),
- swd2jtag_bitseq, TAP_RESET);
- if (retval == ERROR_OK)
- retval = jtag_execute_queue();
-
- /* REVISIT set up the DAP's ops vector for JTAG mode. */
-
- return retval;
-}