/* FLASHCLK_CTRL = 0x05 (enable clock for SLC flash controller) */
target_write_u32(target, 0x400040c8, 0x05);
- /* after reset set other registers of SLC so reset calling is here at the begining*/
+ /* after reset set other registers of SLC so reset calling is here at the beginning */
lpc3180_reset(nand);
/* SLC_CFG = 0x (Force nCE assert, DMA ECC enabled, ECC enabled, DMA burst enabled,
*DMA read from SLC, WIDTH = bus_width) */
- target_write_u32(target, 0x20020014, 0x3e | (bus_width == 16) ? 1 : 0);
+ target_write_u32(target, 0x20020014, 0x3e | ((bus_width == 16) ? 1 : 0));
/* SLC_IEN = 3 (INT_RDY_EN = 1) ,(INT_TC_STAT = 1) */
target_write_u32(target, 0x20020020, 0x03);
COMMAND_PARSE_NUMBER(uint, CMD_ARGV[0], num);
struct nand_device *nand = get_nand_device_by_num(num);
if (!nand) {
- command_print(CMD_CTX, "nand device '#%s' is out of bounds", CMD_ARGV[0]);
+ command_print(CMD, "nand device '#%s' is out of bounds", CMD_ARGV[0]);
return ERROR_OK;
}
}
if (lpc3180_info->selected_controller == LPC3180_MLC_CONTROLLER)
- command_print(CMD_CTX, "%s controller selected",
+ command_print(CMD, "%s controller selected",
selected[lpc3180_info->selected_controller]);
else
- command_print(CMD_CTX,
+ command_print(CMD,
lpc3180_info->is_bulk ? "%s controller selected bulk mode is available" :
"%s controller selected bulk mode is not available",
selected[lpc3180_info->selected_controller]);