real feed_width = 2.1;
real feed_height = 1.25;
-real feed_clear = 0.5;
+real feed_space = 0.5;
real feed_x = 0;
real feed_y = feed_height / 2;
real line_height = 2;
real line_x = 0;
real line_y = feed_y + line_height/2;
-real line_clear = feed_clear;
+real line_space = feed_space;
/* Center point is at the "top" of the feed pad */
/* Draw a line at the edge of the board for alignment */
real mark_y = -edge_y + mils1002mm(line_thickness) / 2;
-
+
line(-hole_x, mark_y, hole_x, mark_y);
/* alignment holes */
-pin_mm_clear(-hole_x, -hole_y, hole_diameter, .35, 0.35, "2", "2");
-pin_mm_clear(hole_x, -hole_y, hole_diameter, .35, 0.35, "2", "2");
+pin_mm_options(-hole_x, -hole_y, hole_diameter, process_ring, "2", "2", "via");
+pin_mm_options( hole_x, -hole_y, hole_diameter, process_ring, "2", "2", "via");
/* vertical pads */
-pad_mm_clear(-v_pad_x, -v_pad_y, v_pad_width, v_pad_height, 0, "2", "2");
-pad_mm_clear( v_pad_x, -v_pad_y, v_pad_width, v_pad_height, 0, "2", "2");
+pad_mm_space(-v_pad_x, -v_pad_y, v_pad_width, v_pad_height, 0, "2", "2");
+pad_mm_space( v_pad_x, -v_pad_y, v_pad_width, v_pad_height, 0, "2", "2");
/* horizontal pads */
-pad_mm_clear(-h_pad_x, h_pad_y, h_pad_width, h_pad_height, 0, "2", "2");
-pad_mm_clear( h_pad_x, h_pad_y, h_pad_width, h_pad_height, 0, "2", "2");
+pad_mm_space(-h_pad_x, h_pad_y, h_pad_width, h_pad_height, 0, "2", "2");
+pad_mm_space( h_pad_x, h_pad_y, h_pad_width, h_pad_height, 0, "2", "2");
/* feed pad */
-pad_mm_clear (feed_x, feed_y, feed_width, feed_height, feed_clear, "1", "1");
+pad_mm_space (feed_x, feed_y, feed_width, feed_height, feed_space, "1", "1");
/* feed line */
-pad_mm_clear (line_x, line_y, line_width, line_height, line_clear, "1", "1");
+pad_mm_space (line_x, line_y, line_width, line_height, line_space, "1", "1");
element_end();