Imported Upstream version 3.1.0

[debian/amanda] / example / chg-mcutil.conf.in

diff --git a/example/chg-mcutil.conf.in b/example/chg-mcutil.conf.in
deleted file mode 100644 (file)
index d16effd..0000000
--- a/example/chg-mcutil.conf.in
+++ /dev/null
@@ -1,66 +0,0 @@
-# config file for the chg-mcutil tape changer program.
-# Used when tpchanger "chg-mcutil" is specified in amanda.conf.
-
-# chg-mcutil is mainly designed for use with Compaq TRU64.
-# chg-mcutil uses a binary program called `mcutil`, a Media
-# changer manipulation utility.  mcutil comes installed with
-# TRU64 5.0x & above.  However, with TRU64 4.0x, it can be
-# located on one of the Associated Product CDs.
-
-# A few OS commands that this script relies on to function
-# correctly.  Please make sure they exist, and are in the 
-# $PATH:
-#
-# date, cut, tr, cat, expr, grep, awk
-#
-
-# Before you can use chg-mcutil within amanda, you need
-# to make sure that `mcutil` can see, and interact with your
-# tape changer.  You need to be able to successfully run the
-# following:
-#
-# mcutil -e drive
-# mcutil -e slot
-# mcutil -m drive slot:#
-# mcutil -m slot:# drive
-#
-
-mcutil @MCUTIL@                #location of the mcutil program
-tape @EXAMPLE_TAPEDEV@ # use ntape for norewind
-                       # {a|m|h|c} suffixes should NOT 
-                       # be tape device since they all
-                       # implement hardware compression
-
-# What are the slot numbers of the tape changer as reported by mcutil?
-firstslot 0
-lastslot 6
-
-# Do you want amanda to determine when you should clean the tape drive?
-use_cleaning 0         # 0 for yes ; 1 for no
-cleanslot 7            # slot containing the cleaning disk
-cleansleep 300         # How long to wait before the cleaning tape finishes (default: 5 min)
-cleanme 45             # number of days before messages popup to clean tape drive
-cleanfile @CONFIG_DIR@/changer/times_cleaned
-lastfile @CONFIG_DIR@/changer/last_cleaned
-
-# Names a status file where the current 'changer' state is stored.
-currentslot @CONFIG_DIR@/changer/currentslot
-
-# Where to log changer debugging info
-logfile @AMANDA_DBGDIR@/changer.debug
-
-
-# To determine what slot is currently used, I query the drive itself.
-# /sbin/mcutil -e drive
-# With a Tape : drive 0 [full,access,source=256]  16
-# Without Tape: drive 0 [empty,access]  16
-#
-# each slot has a source number assigned to it.  I subtract slot 0's source num from the output.
-# If the number is less than 0, no tape is in the drive, else it outputs the current slot number.
-#
-# slot 0 [full,access,source=256] 256
-# slot 1 [full,access,source=257] 257
-# slot 2 [full,access,source=258] 258
-# slot 3 [full,access,source=259] 259
-#
-slot0source 256                # run /sbin/mcutil -e slot to determine slot0 source number.