taperflush 0
autoflush no
-# Specify tape device and/or tape changer. If you don't have a tape
-# changer, and you don't want to use more than one tape per run of
-# amdump, just comment out the definition of tpchanger.
-
-# Some tape changers require tapedev to be defined; others will use
-# their own tape device selection mechanism. Some use a separate tape
-# changer device (changerdev), others will simply ignore this
-# parameter. Some rely on a configuration file (changerfile) to
-# obtain more information about tape devices, number of slots, etc;
-# others just need to store some data in files, whose names will start
-# with changerfile.
-
-# At most one changerfile entry must be defined; select the most
-# appropriate one for your configuration. If you select man-changer,
-# keep the first one; if you decide not to use a tape changer, you may
-# comment them all out.
+# Specify tape device or tape changer.
runtapes 1 # number of tapes to be used in a single run of amdump
-tpchanger "chg-manual" # the tape-changer glue script
-tapedev "@EXAMPLE_TAPEDEV@" # the no-rewind tape device to be used
+tapedev "@EXAMPLE_TAPEDEV@" # tape changer or device to use
-#changerfile "@CONFIG_DIR@/@DEFAULT_CONFIG@/changer"
-#changerfile "@CONFIG_DIR@/@DEFAULT_CONFIG@/changer-status"
-changerfile "@CONFIG_DIR@/@DEFAULT_CONFIG@/changer.conf"
-changerdev "@DEFAULT_CHANGER_DEVICE@"
+# To use vtapes, create some slotN directories (slot0, slot1, etc.) under
+# /var/amanda/vtapes and use this tapedev:
+## tapedev "chg-disk:/var/amanda/vtapes"
+
+# To use a tape library, uncomment this definition. See amanda-changers(7)
+# for more configuration options.
+#
+# define changer myrobot {
+# tpchanger "chg-robot:/dev/sg0" # your changer device file
+# tapedev "tape:@EXAMPLE_TAPEDEV@" # your tape drive device file
+# }
+# tapedev "myrobot"
# If you want Amanda to automatically label any non-Amanda tapes it
# encounters, uncomment the line below. Note that this will ERASE any
# These are referred to by the disklist file. The dumptype specifies
# certain parameters for dumping including:
# auth - authentication scheme to use between server and client.
-# Valid values are "bsd", "krb4", "krb5" and "ssh".
-# Default: [auth bsd]
+# Valid values are "bsd", "bsdudp", "bsdtcp", "krb5", "local",
+# "rsh" and "ssh".
+# Default: [auth "bsd"]
# comment - just a comment string
# comprate - set default compression rate. Should be followed by one or
# two numbers, optionally separated by a comma. The 1st is