controlling the flight or transmitting telemetry
signals, but no record of the flight will be
stored in on-board flash.
+
+ ifdef::easymega,telemega[]
+ |Additional Igniters
+ |four very short beeps
+ |Continuity indication for the four additional pyro
+ channels on TeleMega and EasyMega. One high tone for
+ no continuity, one low tone for continuity. These are
+ produced after the continuity indicators for the two
+ primary igniter channels.
+ endif::easymega,telemega[]
+
|====
ifdef::radio[]
ifdef::radio[disabled, and the radio goes into transmit-only mode.]
ifndef::radio[disabled.]
The only way to get out of this
- mode is to power the flight computer down.
+ mode is to power the flight computer down. See below for how to get the flight
+ computer to come up in Flight/Pad mode at power on.
Idle::
The flight computer is ready to communicate over USB
ifdef::radio[and in packet mode over the radio.]
You can configure
the flight computer, download data or display
- the current state.
+ the current state. See below for how to get the flight
+ computer to come up in Idle mode at power on.
ifdef::telemetrum,easymega,telemega[]
For flight computers with accelerometers (TeleMetrum,
flight computer. These require three connections, one to
the battery, one to the positive power input on the flight
computer and one to ground. Find instructions on how to
- hook these up for each flight computer below. The follow
+ hook these up for each flight computer below. Then follow
the instructions that come with your active switch to
connect it up.