TeleGPS is designed to be easy to use. Requiring no external
components, flying takes just a few steps.
- First, download and install the software from
+ 1. First, download and install the software from
http://altusmetrum.org/AltOS. This will make sure that
you have the right device drivers installed.
- Next, plug in the battery and USB cable and connect TeleGPS to
+ 2. Next, plug in the battery and USB cable and connect TeleGPS to
your computer. This will charge the battery and allow you to
configure the device.
- Start the TeleGPS application and set the callsign and frequency
- on your TeleGPS device; refer to the Configure TeleGPS section
- in the TeleGPS Application chapter for instructions.
+ 3. Start the TeleGPS application and set the callsign and frequency
+ on your TeleGPS device; refer to <<_configure_device>> for instructions.
- Unplug TeleGPS when the battery charger light goes green. This
+ 4. Unplug TeleGPS when the battery charger light goes green. This
will enable the radio and logging portions of the TeleGPS
firmware.
- Connect TeleDongle to your computer and start TeleGPS or start
+ 5. Connect TeleDongle to your computer and start TeleGPS or start
AltosDroid on your android device and connect to TeleBT. Set the
frequency to match the TeleGPS and you should be receiving telemetry.